Yaesu G-1000SA User Manual page 9

Mounting the Rotator and Antenna
A clear plastic round dial heading sheet is provided with the kit, which can be installed with north at any position you
desire. This is particularly useful when you need to have south at the top of the dial (or east or west) instead of north. To
install the heading scale:
Turn on the POWER switch and press the seesaw switch
to set the indicator needle to 180° (straight down), then turn
off the POWER switch.
Grasp the edge of the bezel around the bearing window,
turn it 10° counter-clockwise, and pull it off.
Note the position of the needle, then grasp it at its center,
and pull it straight off.
Determine which compass direction you desire to be upmost,
and install the compass heading label sheet against the azi-
muth scale, so that the small teeth in the edges of the sheet
lock around the edge.
Replace the needle and bezel in the same direction as they
were before (see diagram at the right).
G-800SA/G-1000SA User Manual
I
NSTALLING THE
D H
IAL EADING
Azimuth Indicator Needle
Bezel
S
HEET
Dial Heading Sheet
Page 7