Front Panel; Rear Panel - Yaesu G-1000SA User Manual

Controller Switches & Controls
F
RONT
POWER Switch
Press this switch to turn the controller on to rotate
the antenna. Turn it off when the rotator is not in
use.
LEFT/RIGHT Seesaw Switch
Press the LEFT side of this switch to rotate the an-
tenna counter-clockwise (CCW). Press the RIGHT
side to rotate the antenna clockwise (CW).
OVERLAP Indicator
This red LED glows when the antenna is rotated
beyond about 180° (to 270°) from its original in-
stallation direction (180°). Check this indicator be-
fore rotating the antenna clockwise, and turn the
antenna counter-clockwise to the desired position if
the indicator is on.
Page 2
P
ANEL
R
EAR
SELECT SWITCH
Set this switch to the "
calibrating the internal adjustments of the control-
ler. During normal operation, however, set this switch
to the "
OPERATION MODE
FULL SCALE ADJ Potentiometer
This control calibrates the maximum rotation angle
(range) of the azimuth indicating needle to match
the maximum angle of the rotator.
OVERLAP LED ADJ Potentiometer
This control calibrates the OVERLAP Indicator to
match the azimuth indicating needle.
Rotator Control Cable Jack
The supplied control cable from the rotator connects
to this 6-pin jack.
FUSE Holder
This holder requires a 2-A fuse for 117V AC. If the
fuse is blown, replace only with a fuse of the same
rating.
AC Cable
Connect this cable to the 117V AC wall outlet.
G-800SA/G-1000SA User Manual
P
ANEL
ADJ. MODE " position while
" position.