Summary of Contents for Campania International FT-406 Venn
Page 1
FT-406 Venn Fountain Assembly Instructions Fountain Information: • This fountain holds approximately 3/4 gallon of water. • A fountain cover is not available for this fountain • No refill device or submersible lights are suggested for this fountain. Pump Information: WP450LV - 120 GPH low voltage Pump (16 ft.
Page 2
FT- 406 Venn Fountain Assembly Instructions Fountain Set-Up: Assembly & Installation - A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is installed properly, please read our instructions and tips before you begin. Step 1 - Seek Professional Help: Check if professional installation is recommended for your fountain.
Page 3
FT-406 Venn Fountain Assembly Instructions Step 8 – Using the silicone provided, secure 1 copper spiller (FT-406SPL) lip of the water feature (FT-406A). 8a – The spiller should be even with the wall on the inside of the bowl. Step 9 – While holding the water feature over the tall bowl of the basin (FT-406C), insert the CPVC end of the tubing assembly into the pipe protruding from the bottom of the water feature (FT-406A).
Page 4
Maintenance: Pump Care - The fountain relies heavily on the quality of the pump. A well-maintained pump can last several years. Step 1 - Fully submerge: Ensure the pump is fully submerged at all times to avoid damage. Step 2 - Ensure water level is sufficient: Check water levels regularly as water may evaporate over time, and periodically change water to avoid algae buildup.