Campania International FT-402 Assembly Instructions

Fountain Components
Image Item Description
Kaare Fountain
- Water Feature
Kaare Fountain
- Basin
Assembly & Installation - A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help: Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation: Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop: To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet: Use only a GFCI outlet when running a fountain.
Fountain Information:
• This fountain holds approximately 3-5 gallons of water.
• This fountain uses a small fountain cover: FTNCOV-SM
• No refill device or submersible lights are suggested for this fountain.
Pump Information:
OEMPH140 - 140 GPH Pump (6 ft. cord length)
Tools Required:
Bubble Level
Screwdriver
Component
Quantity
Item #
FT-402A 1
FT-402B 1
Fountain Set-Up:
SHOP NOW
FT-402 Kaare Fountain
Assembly Instructions
Pump Kit Parts List
Image Component
PK140 Pump
(Use only larger adapter)
#10 Stopper
Approx. 12" length of 1/2" black
non-kink tubing
2" length of 5/8" clear tubing
2" length of 1/2" PVC pipe
Hose Clamp
Proudly
MADE IN USA
Quantity
1
1
1
1
1
1
rev 7/11/22