DSC WS4916 Manual

How to remove and reposition a smoke sensor for telus

Hide thumbs Also See for WS4916:

How to Remove and Reposition a DSC Smoke Sensor Model WS4916

Description

This page shows how to remove and reposition a DSC Smoke Sensor Model WS4916

Please read through the directions in its entirety before commencing.

***IMPORTANT customers who use myadt.ca*** Before removing the sensor, place the

panel on test mode through

1. Tap [Home]

2. Tap [Place on Test]

3. Enter your expiration date and time

4. Enter your password

5. Tap [Yes-Proceed]

1. A Phillips screwdriver

2. A thin sharp knife

myadt.ca. After logging in:

Table of Contents

Do you have a question about the WS4916 and is the answer not in the manual?

Page 1 How to Remove and Reposition a DSC Smoke Sensor Model WS4916 Description This page shows how to remove and reposition a DSC Smoke Sensor Model WS4916 Please read through the directions in its entirety before commencing. Preparation ***IMPORTANT customers who use myadt.ca*** Before removing the sensor, place the panel on test mode through myadt.ca.
Page 2 Removal of Smoke Sensor 1. Grab the face of the smoke sensor and twist to the left to release from the back plate 2. Arm and disarm the alarm to clear panel alert 3. Determine if the back plate is attached with adhesive tape or screwed in a.
Page 3 ***If the alert does not clear or if the panel sensor shows tamper, walk through the steps above once more. It could be the sensor cover is not on properly***...