Download Print this page

QOLSYS QS5210-840 Manual

How to remove and reposition a carbon monoxide sensor for telus

Hide thumbs Also See for QS5210-840:

How to Remove and Reposition a Qolsys Carbon Monoxide Sensor Model QS5210-840

Description

This page shows how to remove and reposition a Qolsys Carbon Monoxide Sensor Model

QS5210-840

Please read through the directions in its entirety before commencing.

Preparation

***IMPORTANT customers who use myadt.ca*** Before removing the sensor, place the

panel on test mode through

1. Tap [Home]

2. Tap [Place on Test]

3. Enter your expiration date and time

4. Enter your password

5. Tap [Yes-Proceed]

1. A Phillips screwdriver

myadt.ca. After logging in:

Table of Contents

Do you have a question about the QS5210-840 and is the answer not in the manual?

Page 1 How to Remove and Reposition a Qolsys Carbon Monoxide Sensor Model QS5210-840 Description This page shows how to remove and reposition a Qolsys Carbon Monoxide Sensor Model QS5210-840 Please read through the directions in its entirety before commencing. Preparation ***IMPORTANT customers who use myadt.ca*** Before removing the sensor, place the panel on test mode through myadt.ca.
Page 2 2. Thin sharp knife Removal of Carbon Monoxide Sensor 1. Grab the face of the carbon monoxide sensor and twist to the left to release from the back plate 2. Arm and disarm the alarm to clear panel alert 3. Determine if the back plate is attached with adhesive tape or screwed in a.
Page 3 5. Arm and disarm the alarm to clear panel alert ***If the alert does not clear or if the panel sensor shows tamper, walk through the steps above once more. It could be either the sensor cover is not on properly***...