Advertisement
Install the connected switch for roller shutter
Remove the existing switch
Wire the connected roller shutter switch
UP/Down/Stop/Level control (available via Home+Control app)
The Céliane with Netatmo solution is compatible with roller shutters with a
mechanical or electronic stop, controlled by a standard wired roller shutter switch.
They are not compatible with motors directly controlled by radio control. To check
it, refer to the roller shutter instructions.
It's mandatory to carry out the wiring and installation operations with the
power off (risk to break the product)
Frequency bands: 2.4 - 2.4835 GHz
Power level: < 100 mW
N (neutral) = blue
L (live) = any except blue and green/
yellow
(Earth) = green/yellow
3
Installation of the connected shutter switch into the Zigbee radio
network
ON
4
The light of the connected shutter
switch turns green.
Turn the power back on at the main circuit
breaker.
The indicator lights on the connected shutter
switch that you have wired turns red.
Press the middle of the Home/Away
wireless switch until its light turns
green,
and then stop pressing.
If the roller shutter is closed, it will
automatically goes to the position
«open»
4
Advertisement
