Subscribe to Our Youtube Channel
Related Manuals for Hoymiles HMS-600W-2T
Summary of Contents for Hoymiles HMS-600W-2T
- Page 1 Open Energy for All Single-phase Microinverter USER MANUAL HMS-600W-2T HMS-700W-2T HMS-800W-2T HMS-900W-2T HMS-1000W-2T Region: Europe V202308 hoymiles.com...
- Page 2 However, the content of this manual is continually reviewed and amended, due to product enhancements or feedback from real-world usage. Hoymiles retains the right to modify this manual without prior notice at any time. Please refer to Hoymiles' official website at www.hoymiles.com...
- Page 3 The following documents have been produced to assist you in maximizing the microinverter's potential. Datasheet Datasheet_HMS-1000W Series_EU_EN Quick Installation Guide Quick Installation Guide_HMS-1000W Series_EU_EN Installation Video_HMS-1000W Series_Global_EN Tutorial Videos Hoymiles Compatibility Calculator Others Download the Application Download and install the S-Miles Installer application before use. Revision History Issues 01 (2023-07) V1.0 2023-07-15...
-
Page 4: Table Of Contents
CONTENTS 1. About This Manual 1.1 Purpose 1.2 Audience 1.3 Validity 2. Safety Instructions 2.1 Safety Symbols 2.2 Safety Instructions 3. Product Information 3.1 Overview 3.2 Appearance and Dimensions 3.3 Symbols on the Product 4. Installation Steps 4.1 Preparation 4.2 Mechanical Installation 4.3 AC Side Electrical Installation 4.4 DC Side Electrical Installation 4.5 Start-Up... -
Page 5: About This Manual
This document is valid for: Model Number Output Power (W) HMS-600W-2T HMS-700W-2T HMS-800W-2T HMS-900W-2T HMS-1000W-2T 1000 Notice: Model identifier Meaning Remark Series Name Output Power Level Feature Built-in Wi-Fi Module Number of Inputs Two Inputs © 2023 Hoymiles Power Electronics Inc. All rights reserved. -
Page 6: Safety Instructions
• Only use the microinverter when all technical parameters are observed and applied correctly. • Hoymiles holds no liability for any damage resulting from incorrect or improper operation. Maintenance & Repair • All repairs must be done with qualified spare parts which must be installed in accordance with their intended use and by a licensed contractor or authorized Hoymiles service representative. - Page 7 Disconnect the power supply before any maintenance and repair operation. • Repairs on equipment may only be carried out by Hoymiles Service Team, by a repair team autho- rized by Hoymiels, or by authorized personnel who are thoroughly acquainted with all the warnings and operating procedures contained in this manual.
- Page 8 Do not attempt to repair the product. All repairs should be done using only eligible spare parts. • Do not clean the equipment with rags made of filamentary or corrosive materials to avoid corrosion and electrostatic charges. © 2023 Hoymiles Power Electronics Inc. All rights reserved.
-
Page 9: Product Information
3. Product Information 3.1 Overview Functions Hoymiles HMS-1000W series microinverters are single-phase units designed for module-level operation. They convert DC power generated by PV modules into AC power, and feed the electricity into the power grid. Harnessing the power of two independent MPPT technologies, the HMS-1000W series microinverters maximize energy yield while ensuring system reliability. - Page 10 A versatile tool that can be used tion port on the HMS Trunk Connec- to take apart connectors, tighten tor, which is typically located at the nuts, and loosen nuts. beginning of the AC Trunk. © 2023 Hoymiles Power Electronics Inc. All rights reserved.
- Page 11 The S-Miles Cloud platform offers real-time and historical insights into your solar system’s performance, allowing you to track trends and stay updated on your PV system’s status. S-Miles Cloud Figure 1-5 HMS-1000W Series Microinverters System Diagram © 2023 Hoymiles Power Electronics Inc. All rights reserved.
-
Page 12: Appearance And Dimensions
Notice: The appearance shown here is for reference only. The actual product you receive may differ. Dimensions (mm) 143.5 Notice: The dimensions shown here are for reference only. The actual product you receive may differ. © 2023 Hoymiles Power Electronics Inc. All rights reserved. -
Page 13: Symbols On The Product
CE mark The microinverter conforms to the Low Voltage Directive for the Euro- pean Union. Read manual first Read this manual carefully before performing installation, operation and maintenance. © 2023 Hoymiles Power Electronics Inc. All rights reserved. -
Page 14: Installation Steps
Multi-Microinverter System HMS Connection HMS Trunk HMS Connector HMS Sealing Cap HMS Extension AC cable Cable Connector Connector © 2023 Hoymiles Power Electronics Inc. All rights reserved. - Page 15 Download the S-Miles Installer application. To download, • Scan the QR code located on the right side. S-Miles Installer • Search for “S-Miles Cloud Installer” on App Store or Google Play. © 2023 Hoymiles Power Electronics Inc. All rights reserved.
- Page 16 Cross-section Diameter Maximum Voltage Single-Microinverter System Outdoor Use, Copper Wire 1.5 mm² / 1.0 mm² 8 - 9.5 mm Multi-Microinverter System , Copper Wire 2.5 mm² ≤ 16.5 mm 600 V © 2023 Hoymiles Power Electronics Inc. All rights reserved.
-
Page 17: Mechanical Installation
Given the complexity of balcony installations, consider handrail stability, handrail weight limitations, appropriate mounting methods, and balcony regulations. Seek professional advice if necessary. Single-Microinverter System Hoymiles offers two options for building a single-microinverter system: • Field-Connected Plug Configuration: The second option utilizes a field connection plug. To implement this configuration, prepare an HMS Field Connector and an AC cable with a Schuko Plug. - Page 18 Secure the microinverter to the racking (Torque: 9 N•m). Additional Grounding (if necessary) The AC cables already include earth wires for direct grounding. Use the grounding brackets on the right if external grounding is required. © 2023 Hoymiles Power Electronics Inc. All rights reserved.
-
Page 19: Ac Side Electrical Installation
Push the stripped wire end into the ferrule through the plastic collar and crimp the bootlace ferrule tightly. Notice: Make sure the ends of the conductors are flush with the ends of the plastic collar of the bootlace ferrule. © 2023 Hoymiles Power Electronics Inc. All rights reserved. - Page 20 Connect the HMS Field Connector to the output connector of the microinverter until it clicks into place. Notice: If you want to disconnect the microinverter from the HMS Field Connector, you should use a Disconnect Tool. © 2023 Hoymiles Power Electronics Inc. All rights reserved.
- Page 21 The system overview has been shown below. HMS Extension Connector (optional) AC Output Line Step 1 Connect the HMS Trunk Connector Connect the HMS Trunk Connector to the microinverter. Listen for a click as the connectors engage. © 2023 Hoymiles Power Electronics Inc. All rights reserved.
- Page 22 Use the HMS Connection Cable to connect the adjacent HMS Trunk Connectors. Listen for a click as they engage. Click Rooftop Obstacle Senario If your microinverters are installed too far apart, Hoymiles offers two solutions: • Use a longer HMS Connection Cable •...
- Page 23 Single-phase Microinverter HMS-600W/700W/800W/900W/1000W-2T AC Side Electrical Installation a. Using a longer HMS Connection Cable: Hoymiles offers various cable lengths including 1.1m, 2.3 m, and 4.6 m. If you require a different length, contact Hoymiles sales. b. Using an HMS Extension Connector: the HMS Extension Connector can connect two HMS Connection Cables while it's not typically required.
- Page 24 Step 5 Connect the AC End Cable Connect the AC End Cable to the last HMS Trunk Connector in a series of cables. Listen for a click as they engage. Click © 2023 Hoymiles Power Electronics Inc. All rights reserved.
-
Page 25: Dc Side Electrical Installation
Step 2 Connect to the PV Modules a. Mount the PV modules above the microinverters. b. Connect the DC leads of PV modules to the corresponding DC inputs on the microinverters. © 2023 Hoymiles Power Electronics Inc. All rights reserved. -
Page 26: Start-Up
Check the LED on the connector side of the microinverter, and make sure that the microinverter oper- ates normally. Indicates Fast Green Blink (5 times, 0.3s gap) Start-up Success Green Flashing (1s gap) Producing Power Red Flashing (1s gap) AC Grid Fault © 2023 Hoymiles Power Electronics Inc. All rights reserved. -
Page 27: Setting Up And Activating Monitoring
To enable remote access, you need to connect the microinverter to the S-Miles cloud platform using a router. You can log in to your Hoymiles account on the S-Miles Installer app or S-Miles Cloud Platform, create an online power plant, and add the microinverter by scanning its SN code. - Page 28 Offers access to the alarm code, alarm data, and troubleshooting suggestions. DTU AP Password Setting Offers access to set the AP password. Power Adjustment Offers access to adjust the Active Power. © 2023 Hoymiles Power Electronics Inc. All rights reserved.
-
Page 29: Remote Connection
Notice: Each microinverter has been initially set with a unique AP password, which is printed on a non-removable label affixed to the right side of the microinverter’s silver-colored cover. Upon receiving the microinverter, Hoymiles recommends you modify the initial AP password following the provided steps. - Page 30 Follow the prompts to fill in the required information. c. Tap the Save button to finalize the power plant creation. Notice: For more information about power plant deployment, see S-Miles Installer App Operating Guide. © 2023 Hoymiles Power Electronics Inc. All rights reserved.
- Page 31 Power Adjustment This function offers access to adjust the Active Power. This function provides revenue data over the electricity price, real-time power production Plant Revenue data, and historical power production data. © 2023 Hoymiles Power Electronics Inc. All rights reserved.
-
Page 32: Troubleshooting
1. Check if the grid configuration parameter is correct and upgrade again. Grid configuration parameter error 2. If the fault still exists, contact your dealer or Hoymiles technical support. 1. If the alarm occurs accidentally and the microinverter can still work normally, no special treatment is required. - Page 33 If no, contact the local power operator or change the grid frequency change rate limit via the Hoymiles monitoring system with the consent of the local power operator. Grid Power grid outage Please check whether there is a power grid outage.
- Page 34 1. If the alarm occurs accidentally and the microinverter can still work normally, no special treatment is required. Hardware Error Code 311 2. If the alarm occurs frequently and cannot be recovered, contact your dealer or Hoymiles technical support. © 2023 Hoymiles Power Electronics Inc. All rights reserved.
-
Page 35: Led Indicator Status
The microinverter is powered by the DC side. If the LED light is not on, check the DC side connection. • If the connection and input voltage are normal, contact your dealer or Hoymiles technical support team for further assistance. •... -
Page 36: Wireless Network Troubleshooting
1. Repeat the preceding steps to check your network S-Miles Cloud or S-Miles Installer connection status. application sometimes not displaying data. 2. If the problem persists, contact your installer. © 2023 Hoymiles Power Electronics Inc. All rights reserved. -
Page 37: On-Site Instruction (For Qualified Installers Only)
Every AC breaker is functioning properly and is closed. The DC connection between the microinverter and the PV module is functioning. Notice: If the problem persists, please contact Hoymiles Technical Support Team service@hoymiles.com. © 2023 Hoymiles Power Electronics Inc. All rights reserved. -
Page 38: Decommission
Install the replacement unit. ( See Replace the microinverter in the monitoring platform. - Log in to the S-Miles Cloud at https://world.hoymiles.com. - Navigate to O&M > Micro > Search, find the device that you want to replace, and then click the Device Maintenance icon. -
Page 39: Storaging And Transporting The Microinverter
5 kg and can be fully closed. Properly seal the package with adhesive tape. Dispose of the package according to the local regulations. © 2023 Hoymiles Power Electronics Inc. All rights reserved. -
Page 40: Technical Data
Ensure the PV module’s maximum open circuit voltage is within the microinverter’s operating voltage range. • Hoymiles recommends the maximum current rating at MPP to be equal to or lower than the maximum input DC current. 2. PV module output DC power must not exceed 1.35 times the microinverter’s output AC power. See “Hoymiles Warranty Terms &... -
Page 41: Appendix 1: Installation Map
Single-phase Microinverter HMS-600W/700W/800W/900W/1000W-2T 9. Appendix 1: Installation Map © 2023 Hoymiles Power Electronics Inc. All rights reserved. -
Page 42: Appendix 2: Wiring Diagram - 230Vac Single Phase
Single-phase Microinverter HMS-600W/700W/800W/900W/1000W-2T 10. Appendix 2: WIRING DIAGRAM – 230VAC SINGLE PHASE: © 2023 Hoymiles Power Electronics Inc. All rights reserved. -
Page 43: Appendix 3: Checklist
The AC power cable connections at L, N, and PE and their tightening torques are OK. 12. Appendix 4: Terms and Abbreviations alternating current access point direct current MPPT maximum power point tracking O&M operations and maintenance protective earthing personal protective equipment photovoltaic serial number © 2023 Hoymiles Power Electronics Inc. All rights reserved.
Need help?
Do you have a question about the HMS-600W-2T and is the answer not in the manual?
Questions and answers