GEOMATE SG7 User Manual page 50

4.3.3.3 Manual Base: The receiver will serve neither as a base nor a rover after this
mode is enabled. Users need to configure the receiver manually
For Reference Latitude and Reference Longitude:
There are mainly three methods to enter the reference coordinates and shown as follows:
a) Acquire Current Position: Click this button to acquire current position obtained through
autonomous positioning automatically.
b) Manual Input: Manually input the coordinate of a control point.
c) From CORS: After the receiver logging in CORS, the software can record the coordinate of current
position based on fix solution.
For Sample for Average:
Users can determine the positioning limit and sampling amount. The positioning limit falls into two types:
a) Single Solution Coordinates: Collect the coordinates of receiver obtained through autonomous
positioning.
b) Fixed Solution Coordinates: Only collect coordinates of receiver with a fixed solution.
After the configuration of positioning limit and sampling amount, click
averaging → the progress bar will show the progress → the result will be served as the coordinate of current
position.
If users need to save the changes, please tap
GEOMATE SG7 GNSS USER GUIDE
button.
| 2022-07
Equipment Setup and Operation
to carry out sampling and
P a g e | 50