Mechanical Adjustment; Electrical Adjustment - Sony TC530 Servicing Manual

ge ee
as aa rier
torte ee tet TG
7 "_Pie 2 a.
? a e ee er
= qpeermemms wes
ee
Mechanical Adjustment
Elevation Alignment
The exact vertical
positionings of Head
are adjusted
at the factory and should never need
readjustment.
follows:
{1) Thread a tape. |
(2) Align the upper edges of the Head Cores and upper edge of the tape by turning the Tape Guide located on the left
side of the Erase Head.
ERASE HEAD RECORDING HEAD
Tape Guide \
{To be adjust}
Tape Guide
OD2Smm OO25mm (Not to de adjust)
@REC/PB Head
Adjusting Screw
Brake Alignment
When the tape slacks at stop mode, adjust the Brake as follows. Refer to Fig. 14.
{1) Set the Function Selector Knob to forward position.
Reel Table must keep between 1.0~1.5 mm.
BRAKE LEVER
_" Take-up ree! table
~-
a — .Smm
a
FUNCTION LEVER
Take-uo reel fable
(Fig. 14)
Electrical Adjustment
The alignment is to be performed at a tape speed of 734 ips unless otherwise specified.
in parallel with the VTVM terminals and connect the VTVM to the Speaker Output Jack.
Set the Speaker ON/OFF Switch on.
Connect an 8Q load resisitor