Advertisement
68. EFFECTS FOOTSWITCH:
This jack is for a footswitch such as the Peavey #5100 single
footswitch. This jack will disable the effects board output except in Rotary Speaker mode,
where it will change the speed of the Rotary Speaker from fast to slow.
69. GRAPHIC INSERTS;
These jacks are used to connect to the input of the graphic equalizers,
which feed the equalized outputs. Connecting to these inputs will break the normal connection
to the graphic equalizer.
70. LEFT/L+R OUTPUT:
These parallel (TRS) balanced 1/4" output jacks are the outputs from the
upper graphic equalizer. The signal on these outputs is set by the system mode switch and is
either the left channel or a mono mix of left and right. These output jacks can be used with a
high-quality shielded patch cables such as the Peavey FMJ Patch Cable if the equipment to be
connected is nearby. If the cable needs to be longer than 25 feet, it is best to run a balanced line
using a TRS 1/4" cable or the XLR balanced output jack (#72).
71. RIGHT/MONITOR OUTPUT:
These parallel (TRS) balanced 1/4" output jacks are the outputs
from the lower graphic equalizer. The signal on these outputs is set by the system mode switch
and is either the right channel or a monitor 1 output. These output jacks can be used with a high-
quality shielded patch cables such as the Peavey FMJ Patch Cable if the equipment to be
connected is nearby. If the cable needs to be longer than 25 feet, it is best to run a balanced line
using a TRS 1/4" cable or the XLR balanced output jack (#73).
72. BALANCED LEFT/L+R OUTPUT:
Balanced XLR output for the Left bus when in stereo mode
and the L+R bus when in mono mode. This is the preferred output for transferring the signal
from the mixer to a power amp. Always use high-quality, shielded mic cables like the Peavey
AU-2 Low-Z Cable.
73. BALANCED RIGHT/MONITOR OUTPUT:
Balanced XLR output for the Right bus when
in stereo mode and the Monitor bus when in mono mode. This is the preferred output for
transferring the signal from the mixer to a power amp. Always use high-quality, shielded mic
cables like the Peavey AU-2 Low-Z Cable .
Domestic Version
T/MC3N 1
A,
WARNING
WARN ING
: to reduce the risk of fire or
ELECTRIC SHOCK DO NOT EXPOSE THIS EQUIPMENT
TO RAIN OR MOISTURE.
AVIS:risque de choc electrique-nepasouvrir.
o o
POWER
120 VAC 60 Hz
30 WATTS
POWER
74. A/C POWER INLET:
This is the receptacle for an I EC line cord, which provides AC power to
A
the mixer. Connect the line cord to this connector to provide power to the unit. Damage to the
equipment may result if improper line voltage is used (see line voltage marking on unit).
75. POWER:
The mixer's main power switch. The power on LED indicator (#62) will light when the
unit is powered.
13
Advertisement
