Snapper IRT4 1 Series Manual page 8

Your tiller can be converted to become an even more
versatile garden tool with the addition of the op¬
tional accessory kits listed below. Contact your
SNAPPER dealer for complete information on these
and other kits which may be made available later for
your Model IRT4 tiller.
HILLER/FURROWER KIT—#6-0731
CULTIVATOR SHIELD KIT-#6-0865
OFF-SEASON STORAGE
Thoroughly clean all external surfaces and tines be¬
fore storing the Tiller. The Tiller may be stored on
end, however, the following steps must be taken.
1. Drain gasoline from fuel system and drain the
engine crankcase oil (refer to engine manual for
details).
2. After standing the Tiller on end, check the plugs
in the chain case for leakage. After extended
period, some grease may seep thru upper bear¬
ing races.
3. At the start of the new season, replenish engine
crankcase oil and add gasoline to the fuel tank
after returning the Tiller to its wheels.
4. Before starting, move the ENGINE CONTROL to
STOP and pull rope starter slowly several times.
If excessive resistance is felt, remove the spark
plug and pull rope starter rapidly to spin the engine
and clear Dll from the cylinder. Clean and reinstall
the spark plug before attempting to start the
engine.
MANUFACTURER'S 2 YEAR LIMITED WARRANTY
For two (2) Years from purchase date for the original purchaser's residential, non-commercial use
[ninety (90) days from purchase date for the original purchaser's commercial, rental, or other non-
residential use], SNAPPER POWER EQUIPMENT, through any SNAPPER dealer will replace, free
of charge any part or parts found upon examination by the factory at McDonough, Georgia to be
defective in material or workmanship or both.
All transportation cost incurred by the purchaser in submitting material to a SNAPPER dealer for
replacement under this warranty must be borne by the purchaser.
This warranty does not apply to engines and their components, as these items are warranted
separately by their manufacturers, and does not apply to batteries which are covered separately.
This warranty does not apply to parts that have been damaged by accident, alteration, abuse,
improper lubrication, normal wear, or other cause beyond our control.
There is no other express warranty.
Implied warranties, including those of merchantability and fitness for a particular purpose, are
limited to two (2) years from purchase date for the original purchaser's residential, non-commercial
use [ninety (90) days from purchase for the original purchaser's commercial, rental or other non-
residential use], and to the extent permitted by law any and all implied warranties are excluded. This
is the exclusive remedy. Liabilities for consequential damages, under any and all warranties are
excluded.
Some states do not allow limitations on how long an implied warranty lasts, or do not allow the ex¬
clusion or limitation of incidental or consequential damages, so the above limitation or exclusion
may not apply to you.
This warranty gives you specific legal rights, and you may also have other rights which vary from
state to state.
WARNING: THE USE OF REPLACEMENT PARTS OTHER THAN GENUINE SNAPPER
PARTS MAY IMPAIR THE SAFETY OF SNAPPER PRODUCTS AND WILL VOID
ANY LIABILITY AND WARRANTY BY SNAPPER ASSOCIATED WITH THE USE
OF SUCH PARTS.
IMPORTANT: Please fill out the attached SNAPPER Product Registration Card immediately and
mail to: SNAPPER POWER EQUIPMENT, McDONOUGH, GEORGIA 30253
8
SNAPPER POWER EQUIPMENT
McDonough,GA* 30253
MANUAL 1-5883
(REVISION 1, 7/88 ISSUE)
Printed in U.S.A.