Related Manuals for ABM multiClip Sport
Summary of Contents for ABM multiClip Sport
- Page 1 multiClip Sport / Tour with triple clamp ™ Rotatable 360° 5° crank enables adjustments up to 40 mm by turning the head tube Rotatable 360° Installation and safety information BMW R nineT Racer From model year 2016 • www.ab-m.de ••• info@ab-m.de •...
-
Page 2: Important Safety Advice
Never tie the vehicle at the handlebar. The multiClip requires registration. This product has been designed for a standard vehicle. ABM® Fahrzeugtechnik GmbH makes no warranty or guarantee of any kind for any damages whatsoever arising out of the combination with other component parts not tested by ABM, as a consequence of improper installation or inadequate maintenance. - Page 3 Cylinder screw M6x20 (10.9) Cylinder screw M6x20 (10.9) tighten alternately in 3 steps tighten alternately in 3 steps 6 /12 / 14.5 Nm 6 /12 / 14.5 Nm Clamp • Revision: 01 • 27/07/2021 • © ABM Fahrzeugtechnik GmbH Page 3 of 10...
-
Page 4: Installation
Unscrew both bar ends. Loosen switch units, brake and clutch. Remove the steering nut with washer and clamp screws at the triple clamp. Remove the ignition lock cover. • Revision: 01 • 27/07/2021 • © ABM Fahrzeugtechnik GmbH Page 4 of 10... - Page 5 Using the original screws, attach the speedometer bracket onto the new triple clamp. The two spacer sleeves supplied are installed at the rear attachment points. Tightening torque according to manufacturer's specifications. • Revision: 01 • 27/07/2021 • © ABM Fahrzeugtechnik GmbH Page 5 of 10...
- Page 6 Tighten both clamp screws of the triple clamp. Tightening torque 18 Nm Fully insert both handlebar clamps into the fork clamps. Make sure that the ABM logo is legible for the driver. Push both clamps up against the triple clamp.
- Page 7 Before the final fixation of the handlebars, make sure that under no circumstances they do touch any other parts, even in maximum steering angle. (Image differs from vehicle type) • Revision: 01 • 27/07/2021 • © ABM Fahrzeugtechnik GmbH Page 7 of 10...
- Page 8 Tighten all screws with torque according to page 3. Attach the covers onto the screw heads. Reassemble the missing, previously disassembled parts. • Revision: 01 • 27/07/2021 • © ABM Fahrzeugtechnik GmbH Page 8 of 10...
- Page 9 ™ Installation manual multiClip for BMW nineT Racer from 2017 • Revision: 01 • 27/07/2021 • © ABM Fahrzeugtechnik GmbH Page 9 of 10...
-
Page 10: Final Check
Check the brake fluid level in the reservoir for significant changes. After ca. 100km, the firm fit of all screw connections of the handlebar must be re-checked against the specified tension values. • Revision: 01 • 27/07/2021 • © ABM Fahrzeugtechnik GmbH Page 10 of 10...
Need help?
Do you have a question about the multiClip Sport and is the answer not in the manual?
Questions and answers