Carriage Assembly; Platen Assembly; Tractor Assembly - Panasonic KX-P1180 Service Manual

KX-P1180
4.6 Carriage Assembly
Carriage Shaft Eccentric Cam
Head Gap Lever 1. Loosen the idle pulley bracket screw and release
the timing belt from the pulley.
2. Remove the head gap fever screw, and then
remove head gap lever.
3. Remove the eccentric cam placed the head gap
lever side from chassis opening by turning either
clockwise or counter clockwise.
Carriage Idle Pulley Bracket :
eit 4. Slide out the carriage shaft and remove the car-
As Timing Belt riage assembly.
£Os |
Bh ; Note: When the carriage shaft and its shaft is in-
7 ~Eooentrie Gam talled, e n s u r e that the head gap is correct
Chassis Opening stalled, ensure that the head gap is correct.
When installing the carriage shaft, ensure the
GND spring contacts under pressure on sur-
face of the carriage shaft.
Bushing biaten Bushing 4.7 Platen Assembly
1. Unlatch the platen assembly bushing on both
side by prying with a © screw driver.
2. Lift off the platen assembly.
Note: Keep the platen assembly on a safe place to
avoid dent on rubber.
When installing the platen assembly, ensure
that the GND spring contacts under pressure
© Screw Driver on surface of the platen shaft.
4.8 Tractor Assembly
1. Release the tractor guide shaft E-ring and slide
out the shaft.
2. Unlatch the hooks and then release the bushing
on both side.
3. Lift off the tractor assembly.
Bushing
Bushing