Danger! 2.2 Items supplied When using the equipment, a few safety pre- Please check that the article is complete as cautions must be observed to avoid injuries and specifi ed in the scope of delivery. If parts are damage. Please read the complete operating missing, please contact our service center or the instructions and safety regulations with due care.
4. Technical data Keep the noise emissions and vibrations to a minimum. • Only use appliances which are in perfect wor- Power supply: ......... 18 V DC king order. Dispensing force: ........2000 N • Service and clean the appliance regularly. Feed speed in idle mode max.: ....10 mm/s •...
Page 15
In section 10 (Charger indicator) you will fi nd a NOTE: table with an explanation of the LED indicator on Before you insert the cartridge, check it for punc- the charger. tures or other damage. Use only cartridges that are undamaged or the tool will become damaged. If the battery pack fails to charge, check for the If you want to use a cartridge that has already following:...
6. Operation Guide the sealing gun carefully and evenly along the surface to be sealed. Make sure that the seal- ant has contact with both surfaces to be joined. 6.1 Trigger lever (Fig. 1/Item 1) Use a joint smoothing trowel or your fi nger to The trigger lever (1) can be used in addition for carefully press the sealant into the corners or to infi...
The reprinting or reproduction by any other me- ans, in whole or in part, of documentation and papers accompanying products is permitted only with the express consent of the Einhell Germany Subject to technical changes - 17 - Anl_TE_SG_18_10_Li_SPK7_THA.indb 17 Anl_TE_SG_18_10_Li_SPK7_THA.indb 17...
10. Charger indicator Indicator status Explanations and actions Red LED Green LED Off Flashing Ready for use The charger is connected to the mains and is ready for use; there is no battery pack in the charger Off Charging The charger is charging the battery pack in quick charge mode. The char- ging times are shown directly on the charger.
11. Troubleshooting guide Fault Possible cause Remedy No sealant or adhe- - The cartridge is closed - Open the cartridge sive at the cartridge - Material has hardened in the cart- - Remove the hardened material, use nozzle ridge nozzle and/or in the cartridge the piercing tool if necessary opening - The cartridge is damaged...
* Not necessarily included in the scope of delivery! Please register the product warranty of Einhell brand products. Customers must scan the QR Code of the Serial number in the product or QR code on the box, to additional 6 months warranty for the whole battery and battery charger (Note: Promotion is change without prior notice.
Need help?
Do you have a question about the TE-SG 18/10 Li and is the answer not in the manual?
Questions and answers