Advertisement
The VELOCI digital speed controls feature a new overheat protection function, This function protects the VELOCI against overheating
during operation. If the speed controls temperature exceeds safe levels, the motor function will be temporarily switched off. However,
full steering function is still maintained during this period. When the overheat protection mode is activated, the setup LED will flash
GREEN and RED simultaneously. Simply wait a few minutes to allow the speed control to cool down to normal operating temperatures
and full function will be restored,
Overheating may be caused by the following:
a. Driving in reverse in excess of 8 seconds.
b. The motor used has less than factory limit of turns.
g. Gear mesh is too tight or other drivetrain problems.
d. Inappropriate gear ratios.
e. Repeatedly going from full reverse to full forward instantaneously.
f. Using full brakes too often.
9. Not enough ventilation to the speed control.
ARE
ER RAIL
» IILTDHEAG DATI
Set TIBAK RAMA) o (SER SENGUPTA
ee
ANH ° ULOSLEDARAE
JOIST
APE AARE"
, BAUER
MFR
MTR
ETRE»
Ee
eng
BANGO
VARMA -
Eet
Set
EEN
TE
AER EISE
SS Ri) (HAERTER)
©
R E P R E
AES (SMART
SALAS
TSE
°
. TSA
CP OL
na
STREIT
"E SE" e
JEE LANE / (IR, RRAAR
HECKER
1 (Ness SPECIAL FEATURE
EIS BRRRS SS
erpappa
SHOCK ADJUSTMENT 32222854 RS
Kë
` 420m
Soft Suspension
mi.
seg
Emm
Hard Suspension
Pre
<
Use the included shock clips to adjust for spring pre-load.
SRAM OVTRESIRIN
HRS AS
EERS SER
. Remove wheel cap crew using equipped 3mm hex wrench and detach wheels.
. Replace fresh tires and wheels if the original tires worn out seriously.
. Tighten the wheel cap screw down with the washer.
, ER ZAIRE
Ras
Cuba >
, KOERREN
Mae ERORE
°
NBER
SE MATA
ess
ore
11
Advertisement
