Sony MB-806A Service Manual page 9

(nv '30) ¥908-NM
(30) ¥909-aw
S-h
tarcsecliltate mM anlemtcle(cy Wteiat-lalelelis
Up to six WRU-806A UHF Synthesized Tuner Units
can be installed.
| Notes
* Be sure to power this unit off before installing the
WRU-806A.
*The buttons and display on the front panel of the
WRU-806A may be damaged if they are gripped too
strongly. Always hold the WRU-806A by the side.
+ Do not touch the connectors on the rear panel of the
WRU-806A.
* Be careful of static electricity.
Installing a WRU-806A
1 Hold the WRU-806A by the side and insert into
the slot. Push in until you hear a click.
2 To install two or more units, detach the necessary
number of blank panels by pushing in the top and
bottom tabs of each panel and pulling the panel
out. Then do step | for each unit.
6°
Removing a WRU-806A
On the bottom panel of the tuner, locate the lever
corresponding to the slot where the WRU-806A is
installed and pull the lever forward. The WRU-806A
is ejected from the slot.
r
Bottom Panel
Connections
hen | When using 1 to 6 channels| 1to6 | When using 1 to 6 channels|
AN-820A UHF Antenna
Antenna Cl « (supplied)
ANTENNA B IN ANTENNA A IN
MIX OUTPUT "AC IN
TUNER OUTPUT
= A Connect output A or B
—> B toa mixer or an
amplifier. Power cord
(supplied)
« Make sure to use a pair of antennas.
¢ Make the antenna tips point upward,
amp To AC power source
7 channels or m
AN-820A UHF Antenna
WD-820A UHF
Antenna Divider!
To AC power
source
-
Power cord To AC power
(supplied) source
>
Power cord To AC power
(supplied) source
TUNER OUTPUT Monee
Connect output A or B
to a mixer or an amplifier.
}a
7s
(49) v908-alN