Advertisement
DO NOT cross-connect the power leads from the RoadStart to the battery. Ensure that positive is to positive and negative is to
8
negative. Observe polarity indicator during connection.
Ensure that the unit is fully charged before storage.
9
2.
INTRODUCTION
Easily fits in a glove box or backpack and benefits from being compact and lightweight. Capable of starting an average 7L petrol or 5L
diesel engine. Powered by lithium-ion technology and fully protected against short circuit, overload and reverse polarity. Fitted with a
12,000mAh lithium-ion battery and two USB Outlets (1x 5V/3A, 9V/2A,12V/1.5A and 1x 5V/2A), Type-C input (5V/2A, 9V/2A), this unit
can also supply several full charges for smartphones and tablets/laptops. Digital tyre inflator which reads PSI, KPA and Bar. Maximum
Pressure: 120psi. Suitable for inflating vehicle tyres, bike tyres, balloons/inflatables and balls. Integral LED flashlight with 3 modes
(Solid Light, Strobe, SOS). Supplied with smart battery clamps, inflator hose, Nozzle adaptors and charging cable all stored in a sturdy
hard-shell zip-up case.
3.
SPECIFICATION
Model No:........................................................ RS1200TI
Auxiliary Output: ....................................... USB 1 - 5V/2A
...................................... USB 2 - 5V/3A ,9V/2A,12V/1.5A
Cable & Clamp Length: ....................................... 360mm
Capacity: ............................ 3.7V 12Ah Lith-ion (44.4Wh)
Maximum Current:...............1200A Peak, 600A Cranking
Maximum Starting Capacity: ............. 7L Petrol/5L Diesel
Size (W x D x H): ...............................257 x 53 x 103mm
Voltage: .....................................................................12V
4.
OPERATION
fig.1
11
10
2
1
3
1
Jumpstart port / Smart cable
2
Air hose connection
3
LED Light
4
USB1 Output
5
Type - C Input
6
USB2 Output
4.1.
LED DISPLAY
4.1.1.
Press the Power Button to check the storage level of the jump starter detected on the display, it shows the remaining charge in the
battery and activated output ports (USB1/2) by flashing the "OUT" sign on the display panel. The appliance will automatically power
off when there is no load detected, or charging is complete.
4.1.2.
The display shows different charge levels. The number will reach 100% when the charging is completed.
4.2.
JUMP STARTER CHARGING
4.2.1.
Plug the Charging Cable to USB input port to commence charging.
Or
4.3.
Plug a car adaptor into the socket of an auxiliary port.
4.3.1.
Connect 5V/2A input port of jump starter to the other end of car adaptor.
NOTE: DO NOT charge the jump starter unit immediately after starting engines, but wait at least 30 minutes.
© Jack Sealey Limited
12
7
6
8
5
4
7
Display
8
Minus Button -
9
Pump button
10
Power button
11
Plus Button +
12
Unit selection button
Original Language Version
4
5
6
8
9
9
10
2
3
11
12
7
RS1200TI
Issue 2 (3,F)
1
07/11/23
Advertisement
