STRANDS NUUK E-LINE LICENSE PLATE LED BAR Manual

WIRING INSTRUCTIONS:

(PIN A) RED = +VDC
(PIN B) BLACK = - TO CHASSIS GROUND
(PIN C) WHITE = SIGNAL WIRE TO SWITCH

Assembly of the 3pin DT Connector.

Note:This wiring harness does not require
additional relays.To turn on the light, connect
the signal wire of the switch
(WHITE WIRE) to the positive '+'(HIGHBEAM)

Steps for license plate holder installation:

1.Take off the cardboard from the license plate.
2.Lock the adjustable screw with spring (x 4pcs) into the screw hole positions on the back of the license plate holder, and
adjust the screw depth according to the installation position.Please ensure that the mounting bracket is securely attached in
a manner that ensures it is parallel to the road surface and check LED light fixture perfectly straight with the direction of the
vehicle. This alignment will enhance optimal illumination.Make sure the positioning before moving to step 3.
3.Position the license plate securely, Place silicone spacers with the appropriate height between the installation surface
and the license plate holder, and then lock it in place using the mounting screws.
4.Insert the license plate into the license plate holder, and then firmly press the number plate buckle into place within the
holder
5.When working with electrical wiring and cabling, it is important to take all necessary safety precautions. Make sure that all
electrical connections and cable handling are done in a secure way to avoid the risk of fire or electric shock.
Part no. 809135
MANUAL
NUUK E-LINE LICENSE PLATE LED BAR
Contact us if you need support: support@strands.se or +46(0)320-450450
www.strands.se
www.strandseurope.com
1