Table 4-1: Status Leds - AMC -1BZX User Manual

LED States
Start Up
• Initialization and
discovery of Sensor
Modules (after UTx
is powered up)
• Sensor Warm-up
Network Status
Not applicable to 1BZx
Faults
• Analog input below
configured fault
voltage
• Stuck in Bootloader
• Real-Time Clock
(RTC) disabled or
uninitialized
Alarms
Warning threshold
reached
Alarm threshold
reached
Firmware Upgrade
Boot-loading (erase
phase)
Boot-loading (program
phase)
____________________________________________________________________________________
AMC-1BZ Gas Monitor

Table 4-1: Status LEDs

Network Alarm Status Sensor Module Display Screen Message
Off Solid White
Flashing Green Solid White
(.5 sec. cycle)
Flashing Green Solid Green
(.5 sec. cycle)
Not Applicable Solid Red
Solid Blue Solid Blue
Not Applicable Solid Magenta
Flashing Green Solid Yellow
(.5 sec. cycle)
Flashing Green Solid Red
(.5 sec. cycle)
Flashing Flashing
Blue/Yellow Blue/Yellow
(0.5 sec. cycle) (0.5 sec. cycle)
Flashing Flashing
Blue/Yellow Blue/Yellow
(1 sec. cycle) (1 sec. cycle)
n/a
n/a
n/a
n/a
n/a
n/a
n/a
n/a
Flashing
Blue/Yellow
(0.5 sec. cycle)
Flashing
Blue/Yellow
(1 sec. cycle)
18
AMC Splash Screen
Main Info Screen
(or blank)
No sensor gas readings
shown
Main Info Screen
(or blank)
Gas bar indicates "FAULT"
for affected sensors
Not indicated on Display
Screen
Not indicated on Display
Screen
Not indicated on Display
Screen
Not indicated on Display
Screen
Not indicated on Display
Screen
Logo screen shown when
boot-load completes and
device resets.