Flash Report - Sharp ER-A310 Programming Manual

2. Flash report

REPORT NAME KEY ENTRY
NET3
TL/NS
DPTn
DEPT
DPT#
CR1
DEPT/GROUP
HOURLY
#/TM/ST
⊗
CID
* 7 To read respective reports, it is necessary to follow the proce-
dure below.
Group No. CR1
8 To read respective reports, it is necessary to follow the proce-
*
dure below.
TIME #/TM/ST
TIME : 24 hour system (2 digits)
* 9
XX DEPT#
Dept. code
3. Overflow mark
If the amount in any totalizer other than GT to be printed on X or Z
reports exceeds a programmed limit, the indication mark (overflow
mark) is printed for the totalizer concerned.
The overflow mark may be printed even if a totalizer does not reach
the maximum amount. This occurs, for example, when the amount in
the totalizer gets smaller than the maximum amount due to the entry
of a negative amount after the overflowing of the totalizer. This
means that when the totalizer overflows once, the overflow mark (for
example, " ") is printed.
Samples of respective reports are shown on the following pages.
All manuals and user guides at all-guides.com
MODE
OP X/Z X1/Z1
X Z X1 Z1
3
*
.
.
.
.
.
– 28 –
X2/Z2
DATA FOR READING
X2 Z2
3
*
DEPT. CODE
GROUP CODE
TIME
REMARK
* 9
7
*
* 8