Hitachi RAS-EH36PHLAE Service Manual page 96

Procedure for Disassemble and Reassemble
MODEL : RAS-EH36PHLAE
1. Front Panel
(1) Pull the panel by holding it both lower sides with
both hands.
Fig.
(2) When the panel opens full, pull the inner part of
the right arm inward and pull the panel forward
while closing it gradually.
Fig. 2
2. Front Cover
.
\
"
\
I
CD
CD
Fig. 3
(1) Remove the caps and uncrew at lower portion
of the front cover.
(2) Firmly press 4 hooks at top of front cover by
tools until the hook release from slot.
(3) Pull the front cover to front side.
1
'
-
...
·-
�
\
I
CD
3. Main P.W.B and Reception/Indication P.W.B
(1) Remove each connector from the lead wire.
(2) Remove the two P.W.B supports from the main
P.W.B.
(3) After removing the reception/indication P.W.B
cover, pull the support hook at the right side of
the reception/indication P.W.B and pull out the
P.W.B forward.
Main P.W.B
Reception/Indication
P.W.B
P.W.B cover
4. Tangential air flow fan
(1) Press to unhook (2 places) between drain
pan and cabinet and pull the claw forward
to remove the drain pan.
(2) Unscrew 2 portions at evaporator support
and tangential fan.
(3) Remove the locking hook of the bearing
cover from the cabinet. Gently pull up the
evaporator with bearing cover by holding it
at lower side and pull out tangential fan.
96
P.W.B support
Fig. 5
Fig. 7
Fig. 8