Mapping; Cleaning - Narwal Freo X Ultra User Manual

E. DO NOT stand in front of the
robot, on the threshold or in
narrow aisles to avoid omission.

3.2 Mapping

Before cleaning a new home, the robot needs to explore the environment
and create a map.
Before first-time cleaning, you can trigger mapping by short pressing the
[Start/Stop] button on the base station or tapping "Start Mapping" in the
App.
Note:
1. Once a map is created, it can be edited in the App.
2. Please do not move the base station after a map is created, or you have
to restart mapping. If large furniture in your home is rearranged, it is
recommended to create a new map.

3.3 Cleaning

Select cleaning modes
The product comes with four built-in cleaning modes: Vacuum, Mop, Vacuum
and Mop, and Vacuum then Mop. You can select and adjust parameters like
cleaning cycles, suction, and mop humidity for each mode in the App.
Set Freo Mode
The Freo Mode is an intelligent cleaning assistant. When the Freo Mode is
enabled, the robot can:
• set cleaning parameters based on the environmental data collected by
sensors
• enhance edge and corner cleaning
You can enable the Freo Mode in two ways:
1. Select the Freo Mode in the cleaning modes in the App;
2. Short press [Freo Mode On/Off] button on the base station. When the
indicator turns blue, it means the Freo Mode is on.
Start cleaning task
You can start the robot for cleaning in three ways:
1. Tap [Start Cleaning] in the App
2. Short press the [Start/Stop] button on the robot to start cleaning. The
robot will activate the Vacuum Mode by default.
3. Short press the [Start/Stop] button on the base station to start cleaning.
The robot will activate the Vacuum and Mop Mode by default.
Note: You can adjust the cleaning mode and set more cleaning parameters in the App.
Pause/resume current task
You can pause/resume current task in three ways:
1. Tap [Pause]/ [Resume] in the App;
2. Short press the [Start/Stop] button on the robot；
3. Short press the [Start/Stop] button on the base station.
Mop washing
If the robot is set for multiple mopping runs or the area for cleaning is large,
the robot will automatically return to the base station for mop washing.
The number of mopping runs and returns can be modified in the App before
cleaning starts, and cannot be modified during the current cleaning task.
End current task
The robot will navigate itself back to the base station when cleaning ends.
You can view the current cleaning report in the App.
You can manually end the task in the following three ways and the robot will
return to the base station for self-cleaning and maintenance:
1. Tap [Finish] in the App;
2. Short press the [Recall] button on the robot;
3. Short press the [Recall] button or long press and hold the
button on the base station for 2s.
[Start/Stop]
11