Summary of Contents for ZKTeco SpeedFace-V4L Pro Series
Page 1
Installation Guide SpeedFace-V4L Pro Series Version: 1.0 Due to regular upgrades of systems and products, ZKTeco could not guarantee exact consistency between the actual product and the written information in this manual.
Installation Environment Please refer to the following recommendations for installation: INSTALL INDOORS AVOID INSTALLATION AVOID DIRECT AVOID USE OF ANY ONLY NEAR SUNLIGHT HEAT SOURCE GLASS WINDOWS AND EXPOSURE NEAR THE DEVICE Ÿ Avoid direct contact to sunlight for a long time. Ÿ...
Page 3
Step 2: Insert the expansion tubes into the mounting holes. Step 3: Attach the backplate on the wall using the wall mounting screws. Note: Please insert the wire through the backplate before installation.
Page 4
Step 4: Attach the terminal to the backplate. ① ② Step 5: Attach the terminal to the backplate with a security screw.
Page 5
Door Bell, Exit Button and Alarm Connection Exit Button +12V Bell Power BELL- 485A BELL+ 485B Door Bell Alarm Alarm's Power Switch Door Sensor and Smoke Detection Connection +12V Door Sensor BELL- 485A BELL+ 485B Smoke Detector...
Power Connection 12VDC Recommended Power Supply: 12V ± 10%, at least 3000mA. Ÿ To share the power with other devices, use a power Ÿ supply with higher current ratings. RS485 and Wiegand Connection Access Controller +12V +12V BELL- 485A 485+ RS485 485- Wiegand Reader...
Ethernet Connection RJ 45 IP Address: 192.168.1.130 Default IP Address: 192.168.1.201 Subnet Mask: 255.255.255.0 Subnet Mask: 255.255.255.0 Click COMM. > Ethernet > IP Address on the device, input the IP address and click OK. Lock Relay Connection The system supports Normally Opened Lock and Normally Closed Lock. The NO LOCK (normally opened at power on) is connected with “NO1”...