Table of Contents
Advertisement
BEFORE
OPERATING
Read the manual carefully and completely
important information for the use and safe operation of the machine. Keep this manual handy at
times This machine will assure years Of satisfactory service if operated and maintained
according to recommendations
your local distributor or write to:
!
WARNING
This machine was designed for use on carpet and upholstery extraction applications as per
instructions and recommendations written in thig manual. Any deviation from its proper use or
purpose and the consequential damage that may occur is the sole responsibility of the end
user.
Disconnect the power cord from the outlet before servicing. Do not leave machine connected
to an
electrical
outlet
Do not immerse or use this machine in standing water. Such use may cause ebectric shock.
This equipment is not designed to handle or use combustible/volätile substances such as
gasoline or kerosene, in, on, or near the machine. The use of such materials will cause an
extreme
hazardous
condition.
When using an extension cord, use only a 3 conductor grounding cord — 14 gauge wire or
heavier.
To avoid electric shock, do not expose the unit to rain —store it indoors only.
Use defoamer at ALL times to prevent damage to the vacuum motor(s).
DO not use water in excess Of 1700F (760C)-
•
To prevent seal damage and chemical build-up to the pump system, run clean water through
•
the solution lines after each day's use.
Use Only commercially available carpet cleaning Solutions and defoamer intended for use with
machines of this type. Do not use dyes, bleaches, ammonia, or other additives. The use of
powdered cleaning solution, if not diluted properly, may tæsult in damage to
powdered chemicals are used. premix in a separate container before placing in the solution
tank.
Do not expose machine to freezing temperatures.
ofwater inside metal
All repairs must be done by an authorized EDIC repair statiom
Do not use replacement
DO
NOT
REMOVE
SOLUTION
PLUGGED
IN AND/OR
TO CHECK
WATER
DO
NOT
STORE
UNIT
DO
NOT
RUN
HEATER
FAILURE
TO COMPL Y WITH THE ABOVE
THE MACHINE
before attempting to operate the unit, ThlS manual has
in this manuaL
If additional information is needed, please contact
EDIC
1753
Blake
Los Angeles, CA 90031
when
unattended.
between 32 and 40 degrees F)
parts other than those specified on the parts list.
TANK
SCREEN
RUNNING.
OO
NOT
TEMPERATURE.
IN ANY
LOCATION
THAT
ORY
OR
UNATTENDED
WARRANTY
Ave-
(Keep in mind that the freezing temperature
FOR
ANY
REASON
PUT
ANO
BODY
PART
GETS
BELOW
40 DEGREES
WARNING
INSTRUCTIONS
pump. If
WHILE
MACHINE
IS
IN SOLUTION
TANK
F.
WILL VOID THE
Advertisement
Table of Contents
