Related Manuals for Edic Bravo 300 mh
Summary of Contents for Edic Bravo 300 mh
-
Page 1: Parts List
BRAVO Owner’s Manual & Parts List This equipment is intended for commercial use only BRAVO MODELS 300MH 1753 Blake Avenue ♦ Los Angeles, CA 90031 ♦ 1-(800)-338-EDIC, or in CA 1-(323)-660-1635 ♦ Fax 1-(323)-667-0144... -
Page 2: Before Operating This Machine
For troubleshooting or technical issues, please contact EDIC or the distributor your equipment was purchased from. • Do not use replacement parts other than those specified on the parts list or recommended by an EDIC representative. FAILURE TO COMPLY WITH ABOVE WARNING INSTRUCTIONS WILL VOID THE WARRANTY Grounding Instructions The 120V A/C and the 220V A/C models have been outfitted with the appropriate grounding connector. -
Page 3: Preparing The Machine
PREPARING THE MACHINE 1. Unfasten the two latches which hold the recovery tank to the solution tank. Lift the recovery tank off the solution tank. 2. Pour clean solution into the solution tank. 3. Place the recovery tank back onto the solution tank and fasten the two latches. 4. -
Page 4: Periodic Maintenance
PERIODIC MAINTENANCE All EDIC machines are engineered and built to require a minimum amount of maintenance. But like any machine it does require some care to keep it in optimum working condition. Careful attention to these maintenance instructions will give you maximum operating performance and will increase the life expectancy of your machine. - Page 6 BRAVO PARTS LIST ITEM # PART # DESCRIPTION QTY. F11800 Handle, EDIC, Blue F11791 CORDWRAP C00314-1 HEX BOLT, ¼-20 X 1 C00233 WASHER, ¼” FLAT F00801 RECOVERY TANK D11692 LATCH W/ STRIKER C00310-12 SCREW, 8-32 X ½” E11044 GASKET, 2.25 OD E11045 FOAM DISC, 1.5 OD ½”...
- Page 7 NOTES REVISED 11-08-2012...