Download Print this page

Before Operating This Machine; Grounding Instructions - Edic Bravo 300 mh Owner's Manual

Automotive carpet spotter and upholstery cleaner

Advertisement

BEFORE OPERATING THIS MACHINE

Read this manual carefully and completely before attempting to operate this unit. This manual
has important information for the use and safe operation of the machine. Keep this manual handy at
all times. This machine will assure years of satisfactory service if operated and maintained according to
recommendations in this manual. If additional information is needed, please contact EDIC at 1-800-
338-EDIC or write to:
WARNING!
The machine was designed for use on carpet, floor and upholstery extraction applications as per instructions and
recommendations written in this manual. Any deviation from its proper use or purpose and the consequential damage
that may occur is the sole responsibility of the end user.
Disconnect the power cord from the outlet before servicing. Do not leave the machine connected to an electrical
outlet when unattended.
Do not immerse or use this machine in standing water. Such use may cause electric shock.
This equipment is not designed to handle or use combustible/volatile substances such as gasoline or kerosene, in, on,
or near the machine. The use of such materials will cause an extremely hazardous condition.
When using an extension cord, use only a 3-prong conductor grounding cord- 12 gauge wire or heavier.
To avoid electric shock, do not expose the machine to rain. Store it indoors only.
Do not use the machine for dry vacuuming, as it is not equipped with a fine dust filter.
Use a defoamer at all times to prevent damage to the vacuum motors. If defoamer is not used, or not used sufficiently,
foam from your chemical or chemical left in the carpet from a previous cleaning may be ingested into and damage your
vacuum motors. Failure to use a defoamer may cause water damage to the vacuum system and void warranty.
Do not use water in excess of 135°F (57°C) in the solution tank as it may damage the solution system.
To prevent seal damage and chemical build-up to the pump system, run clean water through the solution lines after
each day's use.
Use only commercially available carpet cleaning solutions and defoamer intended for use with machines of this type.
Do not use dyes, bleaches, ammonia, or other additives. The use of powdered cleaning solution if not diluted properly
may result in damage to the pump. If powdered chemicals are used, premix in a separate container according to
directions on the container before placing in the solution tank. Monitor and clean intake filters to prevent clogs.
Replace damaged filters immediately to prevent damage to pump.
Do not expose the machine to freezing temperatures, or store inside a room or vehicle where the temperature might
drop to freezing temperatures.
For troubleshooting or technical issues, please contact EDIC or the distributor your equipment was purchased from.
Do not use replacement parts other than those specified on the parts list or recommended by an EDIC representative.
FAILURE TO COMPLY WITH ABOVE WARNING INSTRUCTIONS WILL VOID THE WARRANTY

Grounding Instructions

The 120V A/C and the 220V A/C models have been outfitted with the appropriate grounding connector. Make sure the machine is
connected to a grounded outlet having the same configuration as the grounded plug. No adaptor should be used with this machine.
Any modification to the connector will void the warranty.
EDIC
1753 Blake Ave.
Los Angeles, CA 90031

Advertisement

loading