TKB Home TKBETZ1036 Quick Start Manual

TKB
Home
TKB Home
Digitel Heating Thermostat
SKU: TKBETZ1036
OWAVE
PLUS

Quickstart

This is a Z-Wave Device for Europe. To run this device please connect it to your mains power supply. To add this device to your network execute the
following action:
When switch off , tap "Manual"
What is Z-Wave?
Z-Wave is the international wireless protocol for communication in the Smart Home. This device is suited for use in the region mentioned in the Quickstart section.
(For more information about frequency regulations please refer to the frequency coverage overview at Sigma Designs Website )
Z-Wave ensures a reliable communication
every mains powered node can act as a repeater for other nodes (meshed
not in direct wireless range of the transmitter.
This device and every other certified Z-Wave device can be used together
Wave device regardless of brand and origin as long as both are suited for the same frequency range.
If a device supports secure communication
device provides the same or a higher level of security. Otherwise it will automatically turn into a lower level
of security to maintain backward compatibility
For more information about Z-Wave technology,

Product Description

Heating thermostat with LCD Screen, adopt z-wave technology
heating device or on/off valve actuator used in hydronic heating

Prepare for Installation / Reset

Please read the user manual before installing the product.
In order to include (add) a Z-Wave device to a network it must be in factory default state. Please make sure to reset the device into factory default. You can do
this by performing an Exclusion operation
to use the primary controller of the previous network to make sure the very device is excluded

Safety Warning for Mains Powered Devices

ATTENTION: only authorized technicians under consideration of the country-specific installation guidelines/norms may do works with mains power. Prior to the
assembly of the product, the voltage network has to be switched off and ensured against re-switching.

Installation

1. Release the front cover by inserting a screwdriver
2. To pry out the snaps from four directions.
3. After connecting wires, mounting the backing plate in the wall box by screwdriver.
4. Mounting the thermostat on the backing plate.
continuously three times in two seconds
by reconfirming every message (two-way
it will communicate with other devices secure as long as this
devices, white papers etc. please refer to www.z-wave.info
to realize remote and manual control. The thermostat
as described below in the manual. Every Z-Wave controller
into bottom crack.
, "wireless" start to fliker. "wireless"
communication) and
network) in case the receiver is
with any other certified Z-
is able to perform this operation however it is recommended
properly from this network.
ROOM
TKBHOMG
display or vanish after add device successfully.
OWAVE@
is recommended for the control of electric