TKB Home TKBETZ1036 Manual

TKB Home
Digitel Heating Thermostat
SKU: TKBETZ1036
Quickstart
This is a Z-Wave Device for Europe. To run this device please connect it to your mains power supply. To add this device to your network execute the following
action:
When switch off , tap "Manual" continuously three times in two seconds , "wireless" start to fliker. "wireless" display or vanish after add device successfully.

What is Z-Wave?

Z-Wave is the international wireless protocol for communication in the Smart Home. This device is suited for use in the region mentioned in the Quickstart section.
Z-Wave ensures a reliable communication by reconfirming every message (two-way communication) and
every mains powered node can act as a repeater for other nodes (meshed network) in case the receiver is not
in direct wireless range of the transmitter.
This device and every other certified Z-Wave device can be used together with any other certified Z-Wave
device regardless of brand and origin as long as both are suited for the same frequency range.
If a device supports secure communication it will communicate with other devices secure as long as this
device provides the same or a higher level of security. Otherwise it will automatically turn into a lower level of
security to maintain backward compatibility.
For more information about Z-Wave technology, devices, white papers etc. please refer to www.z-wave.info.

Product Description

Heating thermostat with LCD Screen, adopt z-wave technology to realize remote and manual control. The thermostat is recommended for the control of electric heating
device or on/off valve actuator used in hydronic heating .

Prepare for Installation / Reset

Please read the user manual before installing the product.
In order to include (add) a Z-Wave device to a network it must be in factory default state. Please make sure to reset the device into factory default. You can do this
by performing an Exclusion operation as described below in the manual. Every Z-Wave controller is able to perform this operation however it is recommended to use
the primary controller of the previous network to make sure the very device is excluded properly from this network.

Safety Warning for Mains Powered Devices

ATTENTION: only authorized technicians under consideration of the country-specific installation guidelines/norms may do works with mains power. Prior to the
assembly of the product, the voltage network has to be switched off and ensured against re-switching.

Installation

1. Release the front cover by inserting a screwdriver into bottom crack.
2. To pry out the snaps from four directions.
3. After connecting wires, mounting the backing plate in the wall box by screwdriver.
4. Mounting the thermostat on the backing plate.