Installation - Hama 00185871 Operating Instructions Manual

G Operating instruction
Thank you for choosing a Hama product.
Take your time and read the following instructions and information
completely. Please keep these instructions in a safe place for future
reference. If you sell the device, please pass these operating instructions
on to the new owner.
1. Explanation of Warning Symbols and Notes
Warning
This symbol is used to indicate safety instructions or to draw your
attention to speci c hazards and risks.
Note
This symbol is used to indicate additional information or important
notes.
2. Package Contents
• DCF wireless wall clock
• 1 (AA) battery
• These operating instructions
3. Safety Notes
• Protect the product from dirt, moisture and overheating, and only use
it in a dry environment.
• Do not use the product in areas where the use of electronic devices is
not permitted.
• Do not drop the product and do not expose it to any major shocks.
• Do not put the product near interference elds, metal frames,
computers, TVs, etc. Electronic devices and window frames can
negatively affect the product's functionality.
• Do not modify the product in any way. Doing so voids the warranty.
• Keep the packaging material out of the reach of children due to the
risk of suffocation.
• Dispose of packaging material immediately according to locally
applicable regulations.
• The product is intended for private, non-commercial use only.
• Use the product for its intended purpose only.
• Do not use the product in the immediate vicinity of heaters or other
heat sources or in direct sunlight.
• Do not operate the product outside the power limits given in the
speci cations.
• Do not open the device or continue to operate it if it becomes
damaged.
• Do not attempt to service or repair the product yourself. Leave any
and all service work to quali ed experts.
• Keep this product, as all electrical products, out of the reach of
children!
• Use the item only in moderate climatic conditions.
2
Warning – Batteries
• When inserting batteries, note the correct polarity (+ and -
markings) and insert the batteries accordingly. Failure to do so
could result in the batteries leaking or exploding.
• Only use batteries that match the speci ed type. Keep the
instructions for the correct choice of batteries included with the
operating instructions of devices safe for future reference.
• Before you insert the batteries, clean the battery contacts and the
polarity contacts.
• Do not allow children to change batteries without supervision.
• Replace all the batteries in a set at the same time.
• Do not mix old and new batteries, or batteries of different types or
from different manufacturers.
• Remove the batteries from products that are not being used for
an extended period (unless these are being kept ready for an
emergency).
• Do not short-circuit batteries.
• Do not charge batteries.
• Do not burn batteries or heat them up.
• Never open, damage or swallow batteries or allow them to enter
the environment. They can contain toxic, environmentally harmful
heavy metals.
• Remove spent batteries from the product and dispose of them
without delay.
• Avoid storing, charging and using in extreme temperatures and at
extremely low atmospheric pressures (such as at high altitudes).
• Ensure that batteries with damaged housings do not
come into contact with water.
• Keep batteries out of the reach of children.
4. Getting Started
4.1 Inserting the battery
• Remove the battery that was already inserted into the clock, remove
the protective lm if necessary as well as the contact interrupter and
the re-insert the battery with the correct polarity. The clock is ready
for operation.
4.2 Replacing the battery
• Remove and dispose of any used batteries. Insert the new battery
(AA). Ensure that the polarity of the battery corresponds to the
symbols in the battery compartment.

5. Installation

You can mount the wall clock on a wall using the opening on the back.
Warning – Mounting Note:
• Before mounting the clock, ensure that the chosen wall is suitable
for the weight to be mounted, and make sure that there are no
electrical wires, water, gas or other lines at the installation site on
the wall.
• Purchase special fastening materials from specialised dealers.
• Do not mount the product above locations where persons might
linger.