Kubota Z412KW Operator's Manual page 49

OPERATING THE MOWER
2. To set the cutting height, push the mower lift pedal
to raise the mower deck to the top position. Then
adjust the cutting height control dial to the desired
height.
(1) Mower lift pedal
3. Use higher settings for mowing in a rough area or
when mowing tall grass. Lower settings should be
used only for smooth lawns where short grass is
desired.
(1) Cutting height control dial
4. Lower the mower deck by pushing the mower lift
pedal again. This lowers the mower deck from the
"TRANSPORT" position to the "OPERATING"
position.
5. Adjust the anti-scalp rollers' height as follows for
normal operating condition.
IMPORTANT :
• Never allow the rollers to contact the ground
continuously as premature roller wear may
develop if set incorrectly.
• Anti-scalp rollers must maintain a minimum
clearance of 6 mm (0.25 in.) to the ground.
44
(A) "RAISE and LOCK" position
(B) "LOWER" position
Bolt setting
RCK48P, RCK54P
(1) Anti-scalp roller (front, bolt shift type)
RCK60P
(1) Anti-scalp roller (front, bolt shift type)
Z412KW,Z422KW,Z422KWT,Z411KW,Z421KW,Z421KWT