Toshiba Satellite W30t-A Series User Manual page 79

You can also create recovery media and restore the system.
The following items will be described in this section:
Creating Recovery Media
This section describes how to create Recovery Media.
A recovery image of the software on your computer is stored on the Solid
State Drive, and can be copied to USB Flash Memory by using the
following steps:
1.
2.
3.
User's Manual
Creating Recovery Media
Restoring the pre-installed software from your created Recovery
Media
Restoring the pre-installed software from the Recovery Solid State
Drive
Be sure to connect the AC adaptor when you create Recovery Media.
Be sure to close all other software programs except the Recovery
Media Creator.
Do not run software such as screen savers which can put a heavy
load on the CPU.
Operate the computer at full power.
Do not use power-saving features.
Do not write to the media when the virus check software is running.
Wait for it to finish, then disable virus detection programs including any
software that checks files automatically in the background.
Do not use utilities, including those intended to enhance Solid State
Drive access speed. They may cause unstable operation and damage
data.
Do not shut down/log off or Sleep/Hibernate while writing or rewriting
the media.
Set the computer on a level surface and avoid places subjected to
vibrations such as airplanes, trains, or cars.
Do not use on an unstable surface such as a stand.
Select the USB Flash Memory.
The application will allow you to choose from a variety of different
media onto which the recovery image can be copied including USB
Flash Memory.
USB Flash Memory will be formatted and all the data in the USB Flash
Memory will be lost when proceeding.
Turn on your computer and allow it to load the Windows operating
system from the Solid State Drive as normal.
Insert the USB Flash Memory into one available USB port.
5-16