Troubleshooting - Intex 26355EH Owner's Manual

(119PO) ULTRA XTR™ RECTANGULAR / PRISM FRAME™ POOLS ENGLISH 7.5" X 10.3" PANTONE 295U 05/14/2020
PROBLEM
ALGAE • Greenish water.
• Green or black spots
on pool liner.
• Pool liner is slippery
and/or has a bad
odor.
COLORED • Water turns blue,
WATER brown, or black when
first treated with
chlorine.
FLOATING • Water is cloudy or
MATTER IN WATER milky.
CHRONIC LOW • Level is lower than
WATER LEVEL on previous day.
SEDIMENT ON POOL • Dirt or sand on pool
BOTTOM floor.
SURFACE DEBRIS • Leaves, insects etc.
PROBLEM
POOL INLET AIR • Hose clamps are not well-fitted.
ADAPTOR LEAKING
INLET TREADED • Plunger valve not well-fitted.
AIR CONNECTOR
LEAKING
AIR JET VALVE • Air jet valve is not tight and facing up.
LEAKING • Air jet valve internal seal blocked.
• Air jet valve internal seal dirty.
• Air jet valve broken.
SAVE THESE INSTRUCTIONS

TROUBLESHOOTING

DESCRIPTION
• Chlorine and pH
level need
adjustment.
• Copper, iron or
manganese in water
being oxidized by
the added chlorine.
• "Hard water" caused
by a too high pH level.
• Chlorine content is
low.
• Foreign matter in
water.
• Rip or hole in pool
liner or hoses.
• Heavy use, getting in
and out of pool.
• Pool too close to
trees.
CAUSE
CAUSE SOLUTION
• Super chlorinate with shock
treatment. Correct pH to your
pool store's recommended
level.
• Vacuum pool bottom.
• Maintain proper chlorine level.
• Adjust pH to recommended
level.
• Run filter until water is clear.
• Replace cartridge frequently.
• Correct the pH level. Check
with your pool dealer for
advice.
• Check for proper chlorine
level.
• Clean or replace your filter
cartridge.
• Repair with patch kit.
• Finger tighten all caps.
• Replace the hoses.
• Use Intex pool vacuum to
clean bottom of pool.
• Use Intex pool skimmer.
SOLUTION
• Tighten or reinstall hose clamps.
• Tighten or reinstall plunger valve.
• Tighten air jet valve and make sure
it's facing up.
• Turn ON or plug in the pump and
run for few seconds, then turn OFF
or unplug, repeat 3 times.
• Remove air jet valve, flush dirt out with
water and replace valve back.
• Replace a new air jet valve.
119
English
PO
Page 19