Run A Test Cycle - Midea MLV45N1BWW User's Manual & Installation Instructions

Run a test cycle

Run a test cycle to make sure that your washer is properly installed.
1.
Load about 6 pounds (2.7 kg) of laundry into the tub.
2.
Press the Power button to turn on your washer.
3.
Turn the cycle selector to select the Rinse & Spin cycle.
4.
Press the Start Pause button to start the test cycle. Your washer should
not rock or vibrate excessively when water fills the tub or when washing
or spinning. The washer should drain well during the spin cycle.
Caution
•
If you detect any water leaks while the washer is filling or draining,
check the water connections. See Connect the water hoses on page 19
or Connect the drain hose on page 21.
•
If the washer rocks and/or vibrates excessively, level it again. See
Level your washer your washer on page 24.
26