Bosch GSR12V-300FCB22 Operating/Safety Instructions Manual page 12

▶ Using Offset Adapter
You can rotate the offset adapter 12 to any
position around the axis of the tool in 9° in-
crements. See Fig. 6.
A.
Make sure the adapter is locked on the
tool. Pull the adapter 12 away from the
lock ring 14 by approximately 3/16"
(5mm).
B. Rotate the adapter 12 to desired posi-
tion.
C. Let the adapter snap back towards the
lock ring 14.
▶ Inserting and Removing Bits
(Main Hex Drive)
You can insert any 1/4" hex bits directly into
the main hex drive 1 without using any of
the adapters (Fig. 7). The hex drive is mag-
netized and will prevent the bits from falling
out during light drilling or driving.
To remove a bit, simply pull it out.
▶ Inserting and Removing Bits (Hex
Chuck)
Bit holder adapter 10 and offset adapter 12
have a chuck that accepts any 1/4" hex bit.
To insert an accessory, simply pull locking
sleeve 12a backward, insert desired ac-
cessory into chuck and release the locking
sleeve to lock the bit (Fig. 8).
To remove an accessory, pull locking sleeve
backward and remove it from the chuck.
chuck by pulling on bit after it has been
inserted.
2610051918.indd 11
Assembly
To avoid loss of control,
ensure bit is locked in
Fig. 6
B
A
12
C
Fig. 7
Fig. 8
14
m )
5 m
" (
1 6
3 /
x .
m a
1
12a
11
6/11/19 2:10 PM