Xantech SLLC1 Installation Instructions

Speaker level to line level converter

Installation INSTRUCTIONS

DESCRIPTION

The SLLC1 Speaker Level to Line Level Converter is a simple device that allows the MRC44CTL or

MRAUDIO4X4CTL to be used with an auxiliary amplifier.

The SLLC1 is connected to the amplifier (zone audio) output on the multi-room system. The SLLC1

then converts the amplifier output signal to a line-level output signal. The line-level output signal can

now be connected to the pre-amplifier input on an auxiliary amplifier.

The benefit of using an auxiliary amplifier is that it allows the multi-room system to expand in areas

such as indoor pools, large outdoor areas, or even long hallways.

Mounting flanges. No double sided tape needed.

1:11 signal amplitude conversion ratio.

o The SLLC1 is designed to take a 25 Watt system and convert the speaker output to a

typical line level signal.

o The SLLC1 should not be connected to a speaker output that can provide greater than

35 Watts per channel output.

4-Pin screw terminal connector. Use 3 feet of speaker wire, size 12AWG or 14AWG.

Requires stereo RCA cables. For optimal performance, cable should not exceed 6 feet.

No power supply required.

SLLC1

Speaker Level to Line Level Converter

- 1 -

Table of Contents

Do you have a question about the SLLC1 and is the answer not in the manual?

Page 1 Mounting flanges. No double sided tape needed. 1:11 signal amplitude conversion ratio. o The SLLC1 is designed to take a 25 Watt system and convert the speaker output to a typical line level signal. o The SLLC1 should not be connected to a speaker output that can provide greater than 35 Watts per channel output.
Page 2 Connect the amplifier (zone audio) output on the multi-room system to the input on the SLLC1. Speaker LEFT ( + / - ) outputs should be connected to LEFT ( + / - ) SLLC1 inputs. Speaker RIGHT ( + / - ) outputs should be connected to RIGHT ( + / - ) SLLC1 inputs.
Page 3 FIGURE 2: MRC44CTL AND PA635X - 3 -...
Page 4 Xantech and found to be defective by Xantech within the warranty period will be repaired or replaced, at Xantech's option, at no charge. Xantech will not be responsible for the actual cost of installation or removal of the product, nor for any incidental or consequential damages. Some states do not allow the exclusion or limitation of incidental or consequential damages so the above limitation or exclusion may not apply to you.