American Standard Aspirations 7061857 Owner's Manual page 6

7
MOUNT THE CONTROL BOX
Optional: The control box can be mounted with the hook and loop fastener rather than screws if desired.
• Thread the two SCREWS (1) in to the mounting locations marked in the previous step.
NOTE: Do not tighten the screws to the point of being flush with the wall. The screw heads must protrude
approximately ¼" from the wall.
• Place CONTROL BOX BACK (3) over the SCREWS (1) so that the screw heads fit through HOLES (2).
• Slide the CONTROL BOX BACK (3) down to lock on the SCREWS (1).
• Reinstall the control box cover and secure it with SCREW (4).
1 1
2 2
3
4