Advertisement
Problems common
to all units
The location of the various
musical instruments is not
well defined.
are reversed.
speaker.
Reverse the (+) and (—) connections to one of
Connect the speaker cord correctly.
the speakers.
@Connect the speaker cord correctly.
A low frequency hum is
heard when a source is
being played.
The "ERROR"
indicator
appears on the display for
about 1 second.
The power cord or a fluorescent light is located
Keep electrical appliances well away from the
near a connecting cord.
connecting cords.
again.
A "rushing" noise which
is not heard during a
monaural broadcast is
heard during a stereo
broadcast.
Noise is more likely to appear on a stereo signal
if an indoor antenna is being used, change to an
than on a monaural signal.
,
outdoor antenna.
elf a special outdoor antenna is being used, try
changing the installation location, height, and
orientation.
eTry switching off the television or video deck.
ePress the FM mode button on the remote control to
change the reception from stereo to monaural
mode.
Much noise is heard
during a stereo broadcast,
and occasionally the
sound from the program
disappears.
The installation location and orientation of the
antenna are unsuitable.
The transmitting station is a long distance away.
The stereo indicator of the
tuner flickers and does not
light completely.
The sound during a stereo
broadcast is highly
distorted.
There is a building or mountain nearby.
[Distortion is caused by interference between the
signal from the transmitting station (direct wave)
and the signal reflected from the building or
mountain (reflected wave).]
While listening to MW/LW broadcasts
A low frequency hum is
The antenna wire is near the power cord.
eSeparate the antenna wire from the power cord.
heard.
~—57—
Advertisement
