Advertisement
GAS
ONE
CHARCOAL GRILL OPERATION MANUAL
MODEL NO# CG-14
SOCIAL MEDIA
www.gasone.com
/gasoneusa
@gasoneusa
FOR CALIFORNIA CONSUMERS ONLY:
WARNING
!
Cancer and Reproducive Harm.
to www.P65Warnings.ca.gov
Commerce, CA 90040
support@gasone.com
Toll Free: 1.800.698.5070
Customer Service Hours:
M - F: 9 am - 5 pm (PST)
Advertisement
Table of Contents
Related Manuals for GAS ONE CG-14
Summary of Contents for GAS ONE CG-14
- Page 1 CHARCOAL GRILL OPERATION MANUAL MODEL NO# CG-14 SOCIAL MEDIA www.gasone.com /gasoneusa @gasoneusa FOR CALIFORNIA CONSUMERS ONLY: WARNING Cancer and Reproducive Harm. to www.P65Warnings.ca.gov Commerce, CA 90040 support@gasone.com Toll Free: 1.800.698.5070 Customer Service Hours: M - F: 9 am - 5 pm (PST)
- Page 2 IMPORTANT SAFETY INFORMATION THIS MANUAL MUST REMAIN WITH THE PRODUCT AT ALL TIMES FOR OUTDOOR USE ONLY CAUTION: SHARP EDGES. WEAR GLOVES WHEN ASSEMBLING YOUR GRILL. CAUTION: READ AND FOLLOW ALL SAFETY STATEMENTS, ASSEMBLY INSTRUCTIONS, AND USE AND CARE DIRECTIONS BEFORE ATTEMPTING TO ASSEMBLE AND COOK. WARNING: FALIURE TO FOLLOW ALL OF THE MANUFACTURER’S INSTRUCTIONS COULD RESULT IN HAZARDOUS FIRES, EXPLOSIONS, PROPERTY DAMAGE, PERSONAL INJURY OR EVEN DEATH.
- Page 3 PARTS & PIECES LID HANDLE LID AIR VENT COOKING GRID W/HANDLE CHARCOAL GRID FIRE BOWL LID HINGE *Pre Installed BOTTOM AIR VENT ASH TRAY...
- Page 4 PARTS & PIECES A M4*20 HANDLE SCREW M4*10 VENT SCREW M6*30 LEG SCREW *These screws have been installed into the leg. Remove them prior to installation Ø4 HANDLE WASHER Ø6 LEG WASHER *These washers have been installed into the leg. Remove them prior to installation M4 HANDLE NUT M4 VENT NUT...
- Page 5 THIS APPLIANCE IS DESIGN FOR USE ONLY WITH CHARCOAL BRIQUETTES LUMP CHARCOAL AND COOKING WOOD. ATTENTION: THIS GRILL WILL BECOME VERY HOT. DO NOT MOVE IT DURING OPERATION. DO NOT USE IT INDOORS! CAUTION: DO NOT USE SPIRIT, PETROL, OR ANY COMPARABLE FLUIDS FOR LIGHTING OR RE-LIGHTING.
- Page 6 ASSEMBLY Put the legs (10) through the hole of the ash tray (9) and attach to the firebowl (6). Hand tighten to hold them together one by one. Tighten the screws using a screwdriver. Do not twist legs to tighten. Install the bottom air vent (8) to the fire bowl (6).
- Page 7 3. Attach the lid handle (1) to the lid (3). Attach the lid air vent (2) to the lid (3). 4. Place charcoal grid (5) onto the firebowl (6). Place cooking grid (4) onto the firebowl (6). Attach cooking grid handle to the grid.
Need help?
Do you have a question about the CG-14 and is the answer not in the manual?
Questions and answers
How to get more of the screws and washers. I misplaced mine