NORAUTO NO6850 Installation Manual And Security Information page 29

PART NO DESCRIPTION
12 Spring
bracket
13 ф 12 Washer
14 ф 12 Washer
15 M12 Nut
16 M10*20 Bolt
17 Clasp sliding unit
18 M12*85 Bolt
19 Connect unit
20 M8*16 Bolt
21 Foot Pump
MAINTENANCE
1 Before each use, check the compressor to ensure it is not damaged or worn. If in any doubt
DO NOT use the tool.
a Remove it from service immediately and have it replaced or repaired by a qualified
technician.
2 Refilling the hydraulic system with oil is rarely necessary but the oil level should be checked
in the event of a loss of performance.
a To check oil level, ensure the Under Strut Support is fully lowered, remove filler plug and
check that level is within .4" of filler hole. Add hydraulic jack oil if necessary.
WARNING: DO NOT use brake fluid, or any fluid other than hydraulic jack oil as this will cause
serious damage to the jack and invalidate the warranty!
Bleeding the Hydraulic System
3 The Strut Spring Compressor must be securely mounted on a flat and level surface.
4 Wipe the Oil Filler Plug and its surrounding area at the side of the Ram.
5 With the tip of a flat tip screwdriver, pry and remove the rubber Oil Filler Plug.
6 Pour fresh hydraulic jack oil into the Ram until it starts to overflow.
7 Step on the Valve Release Pedal and allow the Under Strut Support to be lowered
completely.
8 While holding the Valve Release Pedal down, rapidly pump the Foot Pedal at least five full
strokes. This should purge the air out of the system.
9 Repeat step 6 above to make sure that the Ram is filled with oil.
10 Wipe the plug and place its edge against the fill-hole and while applying thumb force
behind the plug, work the rubber plug back into the fill-hole with the aid of the flat tipped
screwdriver.
11 After the plug is inserted, wipe off spilled oil from jack exterior with a clean and dry rag.
CAUTION: DO NOT operate the jack when the Oil Filler Plug is removed.
QTY PART NO
clasp 1
4
2
6
1
1
2
1
1
1
DESCRIPTION
22 M6*16 Bolt
23 Pedal unit
24 M8*25 Bolt
25 Pin
26 Hinge pin
27 Pedal
ф 8 Washer
28
29 M8 Nut
30 M10 Nut
31 ф 10 Washer
QTY
EN
1
1
2
1
1
1
2
2
4
4
27