Texas Instruments 990 User Manual page 93

~-------
~
946289-9701
Table E-1. Emulator Messages (Continued)
Message
Description/Recovery Procedure
l!O ERROR XX pathname
An error occurred during input from or output to the specified pathname. The XX is a system
error code defined in Section IV of the Model 990 Computer DXJO Operating System
Reference Manual, Volume VI. pan number 946250-9706. The error codes described in this
user's guide are Input; Output Errors and are displayed as OOXX.
LINE DISCONNECTED
The communication link has been successfully disconnected as requested or a disconnect has
been sensed that was not requested.
LOG DEVICE NOT AVAILABLE
The log device specified in the response to LOG ID: is not available.
NO RECEIVE PATHNAME SPECIFIED
Data has been received for which there is no pathname specified in the receive queue.
OPEN ERROR XX pathname
The Emulator encountered an error in input from or output to the specified pathname. The
XX is a system error code described in Section JV of the Model 990 Computer DXIO
Operating System Reference Manual. Volume VJ, pan number 946250-9706.
OPERATOR MESSAGE QUEUE FULL
More than eight operator messages are queued for display on the operator console or log. The
system halts message output until the queue has emptied. This condition should not occur
unless the .operator has stopped output and delayed restaning the output.
RECEIVED SEND REQUEST COMMAND pathname
A send request has been received and is to be processed.
SEND REQUEST COMMAND ERROR
A send request was received which could not be processed correctly due to an illegal
pathname or no command buffers being a\'ailable.
RPNAME
COMMA~D
pathname
A recei,·e pathname specification string has been received and entered in the receive queue for
the recei\'e de\'ice (RPR or RPU).
RP1'iAME COMMAND ERROR
A recei\'e pathname specification string has been recei\'ed but could not be processed
COrreCtly due
10
an illegaL pathname Or no Command buffers being available.
E-3
Digital Systems Group