Advertisement
Quick Links
Advertisement
Related Manuals for Xantech XTR39
Summary of Contents for Xantech XTR39
- Page 1 Installation Instructions XTR39 & RF2IR 08905084D - 1 -...
- Page 2 INTRODUCTION This document is an addendum to the XTR39 manual. Here you will learn how to setup the XTR39 to communicate with the RF2IR. The XTR39 will send IR commands embedded in an RF signal and send it to the RF2IR. At the RF2IR, the IR command will be emitted to the installed source component (DVD, Tuner, Cable Box, etc).
- Page 3 Global Properties (Convert existing projects to RF projects) Existing XTR39 projects can be converted to work with the RF2IR without modifying every command. This can be done selecting the “Global IR Properties” window. A new “Properties” window will appear that applies to all commands in the project.
- Page 4 Changing an IR Command to a RF Command For projects where only certain commands will be sent via RF transmission, please proceed as intended. After an IR command has been placed under a function button, it can be configured to become an RF command.
- Page 5 RS232 port of the RF2IR. No additional configuration is required. After programming the XTR39 is complete, perform a “Base Unit Transfer” to send the project file to the XTR39 unit. Be sure the XTR39 is connected to the computer USB port.
- Page 6 NOTE: The XTR39 firmware version must be greater than 1.11. To check the firmware, follow the steps below. At Step 2, select “System Info”. Step 1: Press the “Mute” button on the XTR39 and hold it for more than 5 seconds. The XTR39 will enter the setup page.
- Page 7 XTR39 & RF2IR Installation Instructions © 2006 Xantech Corporation This document is copyright protected. No part of this manual may be copied or reproduced in any form without prior Xantech Corporation shall not be liable for operational, technical, or editorial errors/omissions made in this document. 08905084D...