Asus PCI/I-P54SP4 User Manual page 23

PCI/I-P54SP4
User's Manual
The options for the "COM3
&
COM4 Address" line are:
3E8H,2E8H
2E8H,2EOH
220H,228H
338H,238H
Default setting
In
a normal system configuration, it should be unnecessary to
change these defaults.
Parallel Port
The options for "Onboard Parallel Port" are:
378H
3BCH
278H
378H
Disabled
Default setting
This line controls the on-board parallel port connector. If you are
using an 1/0 card with a parallel port, make sure the addresses don't
conflict. IBM PC-compatible computers can have three parallel ports.
•••••••••••••••••••••••••••••••••••••••••
3- 14
Software Guide
Parallel Port Mode
The options for "Onboard LPT Port Mode" are:
Normal
EPP
ECP
ECP&EPP
Default setting
If you have a parallel interface peripheral device that uses one of
the paralell port enhancements listed, set this line for the enhanced
mode your peripheral supports.
Don't change the rest of the settings on this screen with the ex-
ceptions that
if
you install SIMMs that use Slow Refresh DRAM, you
can Enable "Slow DRAM Refresh (1:4)", and if your operating en-
vironment requires the use of the Memory Hole feature you can use
it according to your requirements.
When you are done with this section, press the <Esc> key to go
back to the main screen.
• •• •••••••••••••••••••••••••••••••••••••••
3- 15