Do you have a question about the PROWLER and is the answer not in the manual?
Questions and answers
Randell Murrah
February 27, 2025
There is no aux button on the controller
1 comments:
Mr. Anderson
February 27, 2025
The Foxpro Prowler controller does have an Aux function, but it is not a dedicated button. Instead, the Aux function allows for remote operation of any FOXPRO decoy attached to the Aux Jack (or the FOXJack 5 decoy attached to the Prowler). This means the functionality exists, but it may be integrated into another button rather than having a separate labeled Aux button.
Warranty Statement ................16 1. Getting Started Congratulations on your purchase of the FOXPRO Prowler digital game call! To avoid personal injury and product damage, be sure to read all operating instructions before using the FOXPRO Prowler. 1-1 Prowler Overview...
Alkaline batteries do not last as long in colder temperatures. Installing Batteries in the Prowler Open the battery compartment on the side of the Prowler. You might need to use a coin or a flathead screwdriver to release the tab.
2-4 Playing Sounds The primary function of your Prowler game call is to produce sounds to attract wildlife. This section explains how to turn on the Prowler and the TX433XL and how to start playing sounds.
Prowler. When you are finished calling, use the “Mute” button to silence the Prowler prior to turning off the TX433XL. 11. To turn off the Prowler: Slide the power switch to the off position (to the left). The pilot LED will extinguish.
Keep in mind that any damage to the FOXPRO caller as a result of improper use of the AUX jack is not covered by the warranty, nor will FOXPRO be liable for damage to any connected devices.
5-5 Sound Settings: Fav Mute OR During normal operation, if the Prowler is muted and you request to play a favorite, the sound is queued for playback, but it cannot be heard until the caller is un-muted. Favorite mute override will take care of this and eliminate the need for un-muting the sound upon preset activation.
6-6 Timer/User: Alarm The Prowler remote features a visual alarm that can be set to go off after a span of time. The available times are represented in minutes: 1 – 15 (individual steps) and 20-60 (steps of 5). When the alarm is set and the configured time span passes, the stand timer will display a confirmation message “Stand Timer Alarm...
6. Programming the Prowler The Prowler can store up to 300 sounds in total. From the factory, it’s loaded with 75 premium sounds along with all current free sounds. All free sounds are prefixed with “Free” for easy recognition. The main difference between premium sounds and free sounds is the premium sounds are all live animal recordings whereas the free sounds contain both manmade and real sounds.
The USB port is located inside the rear compartment on the Prowler. Connect your USB cable between the USB port in the Prowler and a USB port on your computer. Make sure the Prowler is powered off while it is connected to your computer! After connecting the Prowler to your computer, launch the utility.
Page 13
File menu on the utility screen and then click on the “Download Free Sounds” menu item. This displays a list of all free sounds available from FOXPRO. You can select one or all of the free sounds to highlight them.
Page 14
“Turn caller off. Connect TX433XL to Jack on caller.” Connect the other end of the 3.5mm cable to the AUX jack on the Prowler game call. Select “OK” on the TX433XL.
Page 15
RF Exposure Safety Notice The Prowler transmitter is not intended to be operated closer than 20cm (about 8 inches) to your body. The transmitter can produce a radiated RF field similar to that of a standard cell telephone, although the duty cycle of this RF field is much lower than that of a cell telephone.
Page 16
Note: Units exported beyond the boundaries of North America are not FCC certified. FOXPRO Inc. makes every attempt at complying with regional regulations governing radio spectrum. However, it is the user’s responsibility to ensure compliance with local laws and ordinances that govern the use of radio controlled devices in the area of operation.
Need help?
Do you have a question about the PROWLER and is the answer not in the manual?
Questions and answers
There is no aux button on the controller
The Foxpro Prowler controller does have an Aux function, but it is not a dedicated button. Instead, the Aux function allows for remote operation of any FOXPRO decoy attached to the Aux Jack (or the FOXJack 5 decoy attached to the Prowler). This means the functionality exists, but it may be integrated into another button rather than having a separate labeled Aux button.
This answer is automatically generated