Table of Contents
Advertisement
Fault
The programme dura-
tion changes during
the wash cycle.
Drum jerks after the
programme starts.
Rushing, hissing
noise.
Detergent or fabric
softener drips off the
seal and collects on
the door or in the seal
fold.
cannot be oper-
ated.
Cause and troubleshooting
Foam detection system switches on a rinse cycle if
foam build-up is too high.
Not a fault – no action required.
▶
This is caused by an internal motor test.
Not a fault – no action required.
▶
Water is flushed under pressure into the detergent
drawer.
Not a fault – normal operating noise.
▶
Too much detergent/fabric softener in the detergent
drawer.
When dosing liquid detergent and fabric softener,
▶
observe the marking in the detergent drawer and
do not dose above this.
Drying phase active.
Not a fault – no action required.
▶
Troubleshooting en
49
Advertisement
Table of Contents
