VCR Commander II Options ... 10 Troubleshooting ... 11 NTRODUCTION The VCR Commander works with your X10 cameras and wireless motion sensors to record video on your VCR. When your motion sensor is activated and turns on a camera, the VCR Commander automatically starts your VCR and records the action.
Basic Setup Press and hold PLAY until the red light stays on. Press the HOUSE button on the motion sensor. The red light on the VCR Commander will go out. This motion sensor will now start your VCR Commander. Point the motion sensor away from where you are working and away from motion so that you can set up the rest of the system.
Page 4
Basic Setup Press REC on the VCR Commander and release it. The red light blinks quickly and then stays on. Press the Record button on your remote and keep pressing until the red light on the VCR Commander briefly goes out and comes back on solid. This means that Record has been learned.
ASIC PERATION Testing the System Now that you have set up your VCR Commander, you are ready to test the system. Your VCR should be on and have the camera selected as its video source. Place the motion sensor in a location where you want it to detect motion. Leave that area and wait one minute for the motion sensor to settle.
VCR Commander II has three features that aren’t available in the standard VCR Commander (UX21A). Programming Multiple Motion Sensors The VCR Commander II works with up to four X10 wireless motion sensors. To setup additional sensors, put batteries in them. Start by programming the first motion sensor: 1.
Page 7
(1) year from the original date of purchase at retail. X10 agrees to repair or replace, at its sole discretion, a defective X10 product if returned to X10 within the warranty period and with proof of purchase.