Jumper Pin Setting - Panasonic LF-D101U Operating Instructions Manual

ENGLISH
ai
Rear panel of this DVD-RAM drive
Rückwand dieses DVD-RAM-Laufwerks
Panneau arriere du lecteur DVD-RAM
BR E ER TER FERN TR TR TER TEE v—..n. nm...„.„unn....e......
meer.» SHEP RHETT ERE ETT EE HET EH BROS
"5"
"on" EF
"OFF" IT
"g"
CELLIER RIRE LL IE FETT RE EEE TH TER»
Jumper pin setting E
a When you insert a jumper pin, "ON" is set. S
SCSI ID setting (Factory Default: 4)
@ Factory use only (No jumper pin) SCSI IDs are a number identifying each SCSI
| unit. Consequently, SCSI IDs must be set so
9 | that no two units duplicate each other on the
© SCSI ID setting SCSI bus.
© | | Note:
@ TERMINATOR setting eHard Disk Drive: 0
@ Factory use only (No jumper pin) eCD-ROM Drive: 3
e SCSI Host Adaptor: 7
Check the SCS} ID (refer to devices instruction
manual) for each device connected on the SCSI
bus.
Set the DVD-RAM drive's ID so as not to
duplicate any other device's ID.
E Terminator setting
(Factory Default: ON)
A terminator refers to a terminating resistance.
The terminators must be set properly when
SCSI units (including the DVD-RAM drive) have
been connected to the personal computer.
eWhen the DVD-RAM drive is a terminating
device (for example, illustration @, @ on
page 20)
Set to ON.
e When the DVD-RAM drive is not a terminating
device (for example, illustration @-@ on
page 20)
Set to OFF.