Omponents; Transceiver; Ransceiver Odule - X10 MK19A Owner's Manual

H H H H H C C C C C U U U U U C C C C C
OUSE OUSE OUSE OUSE OUSE ODES ODES ODES ODES AND ODES AND AND AND AND NIT NIT NIT NIT NIT
Each Module has a specific address
made up of a House Code (red dial on
the face of the Module) and a Unit Code
(black dial on the face of the Module).
The Controller first sends an address and
then a command on the AC power lines.
Only the Module with a matching
address will execute the command. If
more than one Module has the same
address, both Modules will execute the
command.
Addresses are set on the Module by
turning the two dials on the front of the
Module to the desired letter and number
(using a small screwdriver or a coin). The
House Code is selected from the letters A
through P , and the Unit Code is selected
from the numbers 1 through 16.
3 8 3 8
3 8 3 8 3 8
ODES ODES ODES ODES ODES
UNIT CODE
DIAL
T T T T T
RANSCEIVER RANSCEIVER RANSCEIVER RANSCEIVER RANSCEIVER
The Transceiver Module (sold separately)
receives radio frequency (RF) commands
from Mouse Remote to operate a lamp
or appliance plugged into it. The
Transceiver Module also passes on
HOUSE CODE
DIAL
commands over your house wiring to
control other X10 Modules. Note that
(unlike the Lamp Module) you cannot
dim and brighten a lamp connected to
the Transceiver Module.
You should locate the Transceiver
Module centrally in the home for
maximum range when controlled by the
X10 Mouse Remote.
1. 1. 1. 1. 1. Set the House Code
to 'A' .
2. 2. 2. 2. 2. Plug a lamp or
appliance into the

Transceiver

Module.
3. 3. 3. 3. 3. Plug the Transceiver
Module into a
convenient AC
outlet. Fully extend
the antenna.
I I I I I H H H H H
NST NST NSTALLING NST NST ALLING ALLING ALLING ALLING OME OME OME OME OME
A A A A A
UTOMA UTOMATION UTOMA UTOMA UTOMA TION TION TION TION
C C C C C

OMPONENTS

OMPONENTS OMPONENTS OMPONENTS OMPONENTS
M M M M M
ODULE ODULE ODULE ODULE ODULE
3 9 3 9
3 9 3 9 3 9