Download Print this page

Crystal Acoustics System Series Operating Instructions Manual

System series floorstanding speaker
Hide thumbs

Advertisement

Quick Links

System Series
Operating Instructions
© 2000 Crystal Audio

Advertisement

loading

  Related Manuals for Crystal Acoustics System Series

  Summary of Contents for Crystal Acoustics System Series

  • Page 1 System Series Operating Instructions © 2000 Crystal Audio...
  • Page 2: Table Of Contents

    This instruction manual is referred to the following speaker models: System 2 System 4 System Dipole 4 System Center 4 System 5 System 6 System Center 6 SystemBass twin 7 System 8 SystemBass 10 SystemBass 12R Please read this instruction manual before using the System Series Speakers.
  • Page 3: Connecting The Speakers

    • Turn off the subwoofer before connecting the input signal cable on its internal amplifier. • Connect the plus (+) and minus (-) terminals of each speaker to the corresponding plus (+) and minus (-) terminals on the amplifier. • If a biwire type of connection is used (except System 2, System 5 and System Dipole 4 that have single wire binding posts), the gold plated bridges must be taken off.
  • Page 4: Positioning The Speakers

    Thus, the front speakers and the center speaker will have the same distance from the listening position. • The center speaker must be placed on top or beneath of the television. If you place it beneath the television, you must give it an angle in order to face the listeners.
  • Page 5: Adjusting Your Amplifier For The System Series Speakers

    These adjustments are very important for the protection of your speakers. Precautions • The AV amplifier you use must be set to SMALL position for all the System Series Speakers (front, rear & center). • Before operating a subwoofer, make sure that the operating voltage of the local power supply and the subwoofer are identical.
  • Page 6: Specifications

    • Use the best speaker and interconnect cables you can afford. • Do not place the speakers in dusty, humid environment. • Avoid exposure to direct sunlight. Specifications Model Speaker Magnetically shielded Woofer 3” aluminum concave Tweeter 1” aluminum dome Tweeter 1”...
  • Page 7: Systembass Twin

    Single Wire Binding Post Gold Plated Biwire Binding Post Gold Plated Dimensions (WxHxD) mm Model Active subwoofer Woofer Impedance Frequency Response (Hz) Nominal input power in SMALL mode (Watt RMS) Sensitivity (dB/2.83V/1m) Remote controlled, Volune & Frequency control on remote Enclosure Type :Bass reflex Auto Power ON/OFF Dimensions (WxHxD) mm...

This manual is also suitable for:

System 2System center 4System center 6System 8System 5Systembass twin 7 ... Show all