Storing A Station; Automatically Storing Stations - Philips RC 248 Operating Instructions Manual

PRESET STATIONS
i Storing a station
Briefly press the BND key to select the desired waveband. r
[2Tune-in the desired station with the —«/m keys. '
[3] Press the desired preset key (1 - 6) for at least 2 seconds (until you hear a beep).
The display shows the preset number on which the station has been stored. _
@ Recalling a station
Briefly press the BND key to select the desired waveband.
[2] Briefly press the desired preset key (1 - 6).
= Preset Scan (to hear each preset station in turn for 10 seconds)
[1 Press the SCN key (for at least 2 seconds for versions with INF/SCN key)..
The preset number on the display flashes.
[2]To stop the scan, press the SCN key again (for at least 2 seconds for versions with
INF/SCN key).
AUTO-STORE (to automatically store 6 stations on FM or MW*)
This function is useful when travelling through different reception areas.
When you use Auto-Store, the new stations replace any stations previously stored on the
FM3 band (for FM) or the MW2* band (for MW). '
Automatically storing stations .
[Select an FM band or an MW* band with the BND key.
[2] Briefly press the AST key. The set gives a beep and then goes silent. . 7
- The display shows 'AST'. The radio starts searching from the current frequency and
stores 6 stations on the FM3 or MW2* band. When it has finished you hear a beep.
You then hear the station stored on preset.
E Recalling automatically-stored stations
[Select FM3 or MW2* (if not already selected).
[2] Use the preset keys (1 - 6)
Note: Sometimes it may not be possible fo find six stations. In this case, the remaining presets
(for example 5 and 6} are programmed with '000'.
* Only for certain versions